滚筒内颗粒混合过程的实验研究

doi:10.12068/j.issn.1005-3026.2021.01.008

东北大学学报（自然科学版） ›› 2021, Vol. 42 ›› Issue (1): 49-54.DOI: 10.12068/j.issn.1005-3026.2021.01.008

滚筒内颗粒混合过程的实验研究

荣文杰¹，秦德越¹，李宝宽¹，冯昱清²

(1.东北大学冶金学院，辽宁沈阳110819; 2.联邦科学与工业研究组织，澳大利亚墨尔本VIC3168)

出版日期:2021-01-15 发布日期:2021-01-13
通讯作者: 荣文杰
作者简介:荣文杰(1992-)，女，内蒙古赤峰人，东北大学博士研究生；李宝宽(1963-)，男，辽宁辽阳人，东北大学教授，博士生导师.
基金资助:
国家自然科学基金资助项目(51934002).

Experimental Study on Particle Mixing Process in Rotating Drum

RONG Wen-jie¹， QIN De-yue¹， LI Bao-kuan¹， FENG Yu-qing²

1. School of Metallurgy， Northeastern University， Shenyang 110819， China; 2. Commonwealth Scientific and Industrial Research Organization， Melbourne VIC3168， Australia.

Online:2021-01-15 Published:2021-01-13
Contact: LI Bao-kuan
About author:-
Supported by:
-

摘要/Abstract

摘要： 通过自行设计搭建的滚筒实验平台，以玻璃珠为颗粒材料，探究了不同尺寸颗粒的混合/分离过程，并测量不同操作参数下的滚筒功率消耗.实验结果表明:高填充比时颗粒分离现象更明显，呈现典型的小颗粒被大颗粒包围的现象.在低填充比时，对于尺寸接近的颗粒不同转速下的颗粒分离现象不明显.颗粒粒径差距越大，颗粒分离现象越明显.随着滚筒转速和填充比的逐渐增大，功率消耗逐渐增大，而相比之下功率消耗对粒径比的敏感性比较低.

关键词: 滚筒；颗粒混合；转速；填充比；粒径比

Abstract: The mixing and separating process of different-sized particles in a self-designed rotating drum were explored， where the glass beads were taken as particles. The power consumption of rotating drum under different operating parameters were measured. The results show that the particle separation is more evident when the drum is operated at high fill level， where the small particles surrounded by large particles are mostly observed. When the filling rate is low， it is unobvious for the particle separation of the similar size particles at different rotating speeds. The larger difference of the particle size， the more particle separation occurs. With the increasing rotational speed and fill level， the power consumption increases， while the power consumption is relatively less sensitive to the particle size ratio.

Key words: rotating drum; particle mixing; rotational speed; fill level; particle size ratio

中图分类号:

TK05

荣文杰，秦德越，李宝宽，冯昱清. 滚筒内颗粒混合过程的实验研究[J]. 东北大学学报（自然科学版）, 2021, 42(1): 49-54.

RONG Wen-jie， QIN De-yue， LI Bao-kuan， FENG Yu-qing. Experimental Study on Particle Mixing Process in Rotating Drum[J]. Journal of Northeastern University(Natural Science), 2021, 42(1): 49-54.

参考文献

[1]Rong W J，Feng Y Q，Schwarz P，et al.Sensitivity analysis of particle contact parameters for DEM simulation in a rotating drum using response surface methodology［J］.Powder Technology，2020，362:604-614.
[2]Silveério B C S，Kassia K，Santos G，et al.Effect of the friction，elastic，and restitution coefficients on the fluid dynamics behavior of a rotary dryer operating with fertilizer［J］.Industrial & Engineering Chemistry Research，2014，53(21):8920-8926.
[3]Cleary P W.Charge behaviour and power consumption in ball mills:sensitivity to mill operating conditions，linergeometry and charge composition［J］.Internatioanl Journal of Mineral Processing，2001，63(2):79-114.
[4]Soni R K，Mohanty R，Mohanty S，et al.Numerical analysis of mixing of particles in drum mixers using DEM［J］.Advanced Powder Technology，2016，27(2):531-540.
[5]陈炳辰.磨矿分级进展(上)［J］.金属矿山，1999(11):12-17.(Chen Bing-chen.Advance in grinding and classification(part one)［J］.Metal Mines，1999(11):12-17.)
[6]Xu Y，Xu C，Zhou Z，et al.2D DEM simulation of particle mixing in rotating drum:a parametric study［J］.Particuology，2010，8(2):141-149.
[7]Rong W J，Feng Y Q，Schwarz P，et al.Numerical study of the solid flow behavior in a rotating drum based on a multiphase CFD model accounting for solid frictional viscosity and wall friction［J］.Powder Technology，2020，361:87-98.
[8]Ding Y L.Segregation of granular flow in the transverse plane of a rolling mode rotating drum［J］.International Journal of Multiphase Flow，2002，28(4):635-663.
[9]苏天一.滚筒中二元玻璃珠混合影响因素实验与模拟研究［D］.沈阳:东北大学，2014.(Su Tian-yi.Experimental and simulation study on the influence factors of binary particle mixing in the cylinder［D］.Shenyang:Northeastern University，2014.)
[10]樊赟赟，吴凤元，梁力，等.颗粒材料崩塌模拟与特征研究［J］.东北大学学报(自然科学版)，2018，39(6):892-901.(Fan Yun-yun，Wu Feng-yuan，Liang Li，et al.Simulation on granular material collapse and research on its characteristics［J］.Journal of Northeastern University(Natural Science)，2018，39(6):892-901.)
[11] Nityanand N，Manley B，Henein H.An analysis of radial segregation for different sized spherical solids in rotary cylinders［J］.Metallugical Transactions B，1986，17:247-257.
[12]Alizadeh E，Dubé O，Bertrand F，et al.Characterization of mixing and size segregation in a rotating drum by a particle tracking method［J］.AIChE Journal，2013，59(6):1894-1905.
[13]Cleary P W，Owen P.Effect of operating condition changes on the collisional environment in a SAG mill［J］.Mineral Engineering，2019，132:297-315.
[14]李鸿程，董为民，郑广明.球磨机理论临界转速的探讨［J］.新技术新工艺，2012(2):58-60.(Li Hong-cheng，Dong Wei-min，Zheng Guang-ming.Discussion on theoretical critical speed of ball mill［J］.New Technology & New Process，2012(2):58-60.)
[15]Norouzi H R，Zarghami R，Mostoufi N.Insights into the granular flow in rotating drums［J］.Chemical Engineering Research and Design，2015，102:12-25.

滚筒内颗粒混合过程的实验研究

Experimental Study on Particle Mixing Process in Rotating Drum

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 1

编辑推荐

Metrics

本文评价