基于Ergun方程的菱镁球团填充床层阻力特性实验

doi:10.12068/j.issn.1005-3026.2021.03.007

东北大学学报（自然科学版） ›› 2021, Vol. 42 ›› Issue (3): 347-352.DOI: 10.12068/j.issn.1005-3026.2021.03.007

基于Ergun方程的菱镁球团填充床层阻力特性实验

张晟，张晓虎，赵亮，董辉

(东北大学冶金学院，辽宁沈阳110819)

收稿日期:2020-09-06 修回日期:2020-09-06 接受日期:2020-09-06 发布日期:2021-03-12
通讯作者: 张晟
作者简介:张晟(1993-)，男，河南焦作人，东北大学博士研究生；董辉(1969-)，男，辽宁锦州人，东北大学教授，博士生导师.
基金资助:
辽宁兴辽人才计划(XLYC1802122)；辽宁省重点研发计划项目(2019JH2 / 10100007).

Experiment of Resistance Characteristics for Magnesite Pellets Packed Bed Based on Ergun Equation

ZHANG Sheng， ZHANG Xiao-hu， ZHAO Liang， DONG Hui

School of Metallurgy， Northeastern University， Shenyang 110819， China.

Received:2020-09-06 Revised:2020-09-06 Accepted:2020-09-06 Published:2021-03-12
Contact: DONG Hui
About author:-
Supported by:
-

摘要/Abstract

摘要： 菱镁球团重烧竖炉内的气流流动分布较为复杂，获得料层阻力特性规律是开展竖炉内气体流动及气固换热过程研究的基础.从颗粒填充床的气体动力学出发，以Ergun方程为基础，首先系统测量了菱镁球团颗粒关键宏观特性——粒径分布、密度、球形度及空隙率;通过冷态实验修正了Ergun方程中黏性阻力系数和惯性阻力系数，获得了适用于描述菱镁球团床层阻力特性的关系式.结果表明:球形度及空隙率均随颗粒粒径的增加而增加;单位料层压降随气体流速的增加而增加，且增长趋势逐渐加剧，反之随着颗粒粒径的增加而减小.

关键词: 阻力损失;菱镁球团;Ergun方程;球形度;空隙率

Abstract: The gas flow distribution in the magnesite shaft furnace is relatively complicated. Obtaining the resistance characteristics in the magnesite pellets packed bed is the basis for the research on the gas flow and gas-solid heat transfer process. Starting from the gas dynamics of the gas-solid packed bed， based on the Ergun equation， the key macroscopic properties of the magnesite pellets， including particle size distribution， density， sphericity and voidage， were systematically measured. The viscous resistance coefficient and the inertial resistance coefficient in the Ergun equation were corrected through cold experiments， and a relational equation suitable for describing the resistance characteristics of the magnesite pellet bed was obtained. The results showed that the sphericity and voidage increase with the increase of particle size. The pressure drop increases with the increase of gas flow rate， and the increasing trend gradually intensifies. On the contrary， it decreases with the increase of particle size.

Key words: pressure loss; magnesite pellets; Ergun equation; sphericity; voidage

中图分类号:

TK05
TK124

张晟，张晓虎，赵亮，董辉. 基于Ergun方程的菱镁球团填充床层阻力特性实验[J]. 东北大学学报（自然科学版）, 2021, 42(3): 347-352.

ZHANG Sheng， ZHANG Xiao-hu， ZHAO Liang， DONG Hui. Experiment of Resistance Characteristics for Magnesite Pellets Packed Bed Based on Ergun Equation[J]. Journal of Northeastern University(Natural Science), 2021, 42(3): 347-352.

参考文献

[1]丁建华，陈正海，杨国俊，等.中国菱镁矿成矿规律及资源潜力分析［J］.中国地质，2013，40(6):1699-1711.(Ding Jian-hua，Chen Zheng-hai，Yang Guo-jun，et al.Metallogeny and resource potential of magnesite deposits in China［J］.Geology in China，2013，40(6):1699-1711.)
[2]Ergun S，Orning A A.Fluid flow through randomly packed columns and fluidized beds［J］.Industrial and Engineering Chemistry，1949，41(6):1179-1184.
[3]Ergun S.Fluid flow through the packed columns［J］.Chemical Engineering Progress，1952，48:89-94.
[4]Nemec D，Levec J.Flow through packed bed reactors.Part 1:single-phase flow［J］.Chemical Engineering Science，2005，60(24):6947-6957.
[5]Wu Z X，Wu Y W，Wang C L，et al.Experimental and numerical study on helium flow characteristics in randomly packed pebble bed［J］.Annals of Nuclear Energy，2019，128:268-277.
[6]Allen K G，Von B T W，Krger D G.Packed bed pressure drop dependence on particle shape，size distribution，packing arrangement and roughness［J］.Powder Technology，2013，246:590-600.
[7]Feng J S，Zhang S，Dong H，et al.Frictional pressure drop characteristics of air flow through sinter bed layer in vertical tank［J］.Powder Technology，2019，344:177-182.
[8]Feng J S，Dong H，Dong H D.Modification of Ergun’s correlation in vertical tank for sinter waste heat recovery ［J］.Powder Technology，2015，280:89-93.
[9]张四宗，温治，刘训良，等.颗粒形状对烧结矿填充床内渗透系数和阻力系数的影响［J/OL］.中南大学学报(自然科学版)，2020.https://kns.cnki.net/kcms/detail/43.1426.N.20200728.1426.002.html.(Zhang Si-zong，Wen Zhi，Liu Xun-liang，et al.Effects of particle shape on permeability and resistance coefficients of sinter packed bed［J/OL］.Journal of Central South University(Science and Technology)，2020.https://kns.cnki.net/kcms/detail/43.1426.N.20200728.1426.002.html.)
[10]张承全，高军，吕立鹏，等.单一尺寸圆柱颗粒填充床的阻力特性［J］.化工学报，2019，70(11):4181-4190.(Zhang Cheng-quan，Gao Jun，Lyu Li-peng，et al.Resistance characteristics of bed packed with mono-size cylindrical particles［J］.CIESC Journal，2019，70(11):4181-4190.)
[11]Clavier R，Chikhi N，Fichot F，et al.Experimental investigation on single-phase pressure losses in nuclear debris beds:identification of flow regimes and effective diameter ［J］.Nuclear Engineering & Design，2015，292(B4):222-236.
[12]Crawford C W，Plumb O A.The influence of surface roughness on resistance to flow through packed beds［J］.Journal of Fluids Engineering，1986，108(3):343-347.
[13]Tan K，Sam T，Jamaludin H.The onset of transient convection in bottom heated porous media［J］.International Journal of Heat and Mass Transfer，2003，46(15):2857-2873.
[14]Zou R P，Yu A B.Evaluation of the packing characteristics of mono-sized non-spherical particles ［J］.Powder Technology，1996，88(1):71-79.
[15]国家技术监督局.铁矿石(烧结矿、球团矿)容积密度测定方法:GB/T 14202—1993［S］.北京:中国标准出版社，1993:1-4.(The State Bureau of Quality and Technical Supervision.Iron ores (sinter and pellets) determination of bulk density:GB/T 14202—1993［S］.Beijing:Standards Press of China，1993:1-4.)
[16]中华人民共和国国家质量监督检验检疫总局，中国国家标准化管理委员会.铁矿石—表观密度、真密度和孔隙率的测定:GB/T 24586—2009［S］.北京:中国标准出版社，2009:1-8.(General Administration of Quality Supervision，Inspection and Quarantine of the People's Republic of China，Standardization Administration.Iron ores determination of apparent density，true density and porosity:GB/T 24586—2009［S］.Beijing:Standards Press of China，2009:1-8.)
[17]Tian F Y，Huang L F，Fan L W，et al.Wall effects on the pressure drop in packed beds of irregularly shaped sintered ore particles［J］.Powder Technology，2016，301:1284-1293.
[18]Liu Y，Wang J Y，Cheng Z L，et al.Experimental investigation of fluid flow and heat transfer in a randomly packed bed of sinter particles［J］.International Journal of Heat and Mass Transfer，2016，99:589-598.
[19]Foumeny E A，Kulkarni A，Roshanis S，et al.Elucidation of pressure drop in packed-bed systems ［J］.Applied Thermal Engineering，1996，16(3):195-202.
[20]Ozahi E，Gundogdu M Y，Carpinlioglu M .A modification on Ergun`s correlation for use in cylindrical packed beds with non-spherical particles ［J］.Advanced Powder Technology，2008，19(4):369-381.
[21]Macdonald I F，El-Sayed M S，Mow K，et al.Flow through porous media-the Ergun equation revisited ［J］.Industrial & Engineering Chemistry Fundamentals，1979，18 (3):199-208.

基于Ergun方程的菱镁球团填充床层阻力特性实验

Experiment of Resistance Characteristics for Magnesite Pellets Packed Bed Based on Ergun Equation

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 1

编辑推荐

Metrics

本文评价