东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2009, Vol. 30 ›› Issue (8): 1155-1158.DOI: -

• 论著 • 上一篇    下一篇

某重型燃气轮机喷嘴组雾化特性的试验研究

刘凯;蔡九菊;张宝诚;马洪安;   

  1. 东北大学材料与冶金学院;沈阳航空工业学院动力与能源工程学院;
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2009-08-15 发布日期:2013-06-22
  • 通讯作者: Liu, K.
  • 作者简介:-
  • 基金资助:
    国家高技术研究发展计划项目(2002AA503010/ZXD0705)

Experimental study on the atomization behavior of fuel injector group of a heavy-duty gas turbine

Liu, Kai (1); Cai, Jiu-Ju (1); Zhang, Bao-Cheng (2); Ma, Hong-An (2)   

  1. (1) School of Materials and Metallurgy, Northeastern University, Shenyang 110004, China; (2) School of Power and Energy Engineering, Shenyang Institute of Aeronautical Engineering, Shenyang 110034, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2009-08-15 Published:2013-06-22
  • Contact: Liu, K.
  • About author:-
  • Supported by:
    -

RichHTML

1

PDF (PC)

803

摘要： 讨论了某重型燃气轮机(E级)燃烧室燃料喷嘴组雾化特性试验研究结果.应用美国TSI公司LDV/PDPA系统测得不同压力下喷嘴组雾化粒度及分布,应用软件识别方法测得喷嘴组喷雾锥角.试验结果表明:喷嘴组雾化粒度对压力变化敏感,当压力由0.4 MPa升高到1.2 MPa时,粒度由23.22μm降低到10.11μm,而雾化锥角则由73.5°降低到69.5°.试验数据为喷嘴组的设计改型提供了可靠的依据.

关键词: 重型燃气轮机, 燃料喷嘴组, 雾化特性, 索特平均直径, 雾化锥角

Abstract: The atomization behavior of the fuel injector group in the combustion chamber of a Grade E heavy-duty gas turbine was experimentally investigated and the results were discussed. Applying the LDV/PDPA system supplied by TSI Co. to measuring the atomized particle size from the fuel injector group and its distribution under different pressures, the spray cone angle was given by relevant recognition software. The results showed that the atomized particle size is sensitive to pressure. For instance, the particle size decreases from 23.32 to 10.11μm with the pressure increasing from 0.4 to 1.2 MPa, whereas the spray cone angle decreases to 69.5° from 73.5°. Those experimental data provides a reliable basis for the design and R& D of injector group.

中图分类号: