东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2012, Vol. 33 ›› Issue (10): 1470-1473+1520.DOI: -

• 论著 • 上一篇    下一篇

基于集中质量块法的叶片试验模型的模态调节方法

罗忠;张海军;张凯;王德友;   

  1. 东北大学机械工程与自动化学院;中航工业集团沈阳发动机设计研究所;
  • 收稿日期:2013-06-19 修回日期:2013-06-19 出版日期:2012-10-15 发布日期:2013-04-04
  • 通讯作者: -
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(51105064);;

Modal adjustment method based on lumped mass for test model of blade

Luo, Zhong (1); Zhang, Hai-Jun (1); Zhang, Kai (1); Wang, De-You (2)   

  1. (1) School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China; (2) Shenyang Aeroengine Design Institute, Aviation Industry Corporation of China, Shenyang 110042, China
  • Received:2013-06-19 Revised:2013-06-19 Online:2012-10-15 Published:2013-04-04
  • Contact: Zhang, H.-J.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

857

摘要： 基于集中质量块法研究了叶片相似缩尺试验模型的模态调节问题.首先根据薄板的小挠度理论假设,得出了考虑质量块分布的薄板固有频率理论计算公式,通过引入质量块位置比值坐标,重点分析了集中质量块在薄板上的位置和质量块材料对薄板振动特性的影响规律.最后通过工程实例给出基于集中质量块的具体应用方法,并用有限元法从固有频率和模态振型两方面得以验证和对照,确认了所提出的模态调节方法的正确性和有效性.

关键词: 叶片, 试验模型, 相似, 集中质量块, 模态

Abstract: Modal adjustment method for similar test model of blade was studied on the basis of the lumped mass method. Firstly, the natural frequency formulas of thin plate with lumped mass distribution were obtained according to the small plate deflection theory assumption. Secondly, the vibration characteristics influence rules of the materials and position of the lumped mass on the thin plate were analyzed using ratio coordinate system. Finally, the application method based on lumped mass was given through a practical example, and the effectiveness and correctness of the adjustment method were verified with finite element method from natural frequency and modal shapes.

中图分类号: