东北大学学报(自然科学版) ›› 2012, Vol. 33 ›› Issue (4): 542-545.DOI: -

• 论著 • 上一篇    下一篇

COREX 3000竖炉炉顶的布料过程

李强;刘栋梁;张丽娟;邹宗树;   

  1. 东北大学材料与冶金学院;宝山钢铁股份有限公司研究院;
  • 收稿日期:2013-06-19 修回日期:2013-06-19 发布日期:2013-04-04
  • 通讯作者: -
  • 作者简介:-
  • 基金资助:
    国家科技支撑计划项目(2011BAE04B01,2011BAE04B02);;

Burden charging process for shaft furnace of COREX 3000

Li, Qiang (1); Liu, Dong-Liang (1); Zhang, Li-Juan (1); Zou, Zong-Shu (1)   

  1. (1) School of Materials and Metallurgy, Northeastern University, Shenyang 110819, China; (2) Baoshan Iron and Steel Co. Ltd., Shanghai 200941, China
  • Received:2013-06-19 Revised:2013-06-19 Published:2013-04-04
  • Contact: Li, Q.
  • About author:-
  • Supported by:
    -

摘要: 以COREX 3000预还原竖炉炉顶的万向节布料器为研究对象,根据量纲和谐原理推导相似准数,并按照1∶5比例建立冷态模型,研究了布料器操作参数对布料规律的影响.研究结果表明:方向节布料器溜槽倾角变化对堆密度径向分布影响显著,随着倾角增大,堆密度最小值向炉墙侧移动;料线高度增加,使堆密度峰值降低,且向炉墙侧移动;溜槽转速对堆密度分布影响较小.

关键词: COREX3000, 竖炉布料, 料堆形状, 径向堆密度分布, 冷态实验

Abstract: The burden charging process was experimentally studied for the gimbal distributor of pre-reduction shaft furnace of COREX 3000. The similarity criteria were derived by dimension-harmony principle, and a 1:5 scale cold model was constructed. The effect of distributor parameters on the behavior of burden charging was studied. The results showed that the chute inclination angle of the gimbal distributor has significant effect on the radial bulk density distribution. The position of minimum bulk density moves to the shaft wall with increasing the chute inclination angle. The peak value of bulk density decreases and its position moves to the shaft wall with the elevation of stock line. The chute rotation speed has little effect on the bulk density.

中图分类号: