东北大学学报（自然科学版）

东北大学学报:自然科学版 ›› 2016, Vol. 37 ›› Issue (8): 1149-1154.DOI: 10.12068/j.issn.1005-3026.2016.08.018

• 机械工程 • 上一篇    下一篇

线接触端曲面齿轮齿面的接触算法

林超， 顾思家   

  1. (重庆大学 机械传动国家重点实验室， 重庆400044)
  • 收稿日期:2015-04-14 修回日期:2015-04-14 出版日期:2016-08-15 发布日期:2016-08-12
  • 通讯作者: 林超
  • 作者简介:林超(1958-)，男，重庆人，重庆大学教授，博士生导师.
  • 基金资助:
    国家自然科学基金资助项目(51275537).

Tooth Contact Algorithm of Line Contact Curve-Face Gear

LIN Chao， GU Si-jia   

  1. The State Key Laboratory of Mechanical Transmission， Chongqing University， Chongqing 400044， China.
  • Received:2015-04-14 Revised:2015-04-14 Online:2016-08-15 Published:2016-08-12
  • Contact: LIN Chao
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

1134

摘要： 为了研究线接触端曲面齿轮副的齿面接触特性，建立了端曲面齿轮副的传动坐标系，推导出齿轮副的瞬时回转轴及瞬轴面.应用齿廓啮合基本定理，从几何学的角度提出了线接触端曲面齿轮副齿面接触算法，求解出齿轮副的齿面接触印痕与齿廓点.根据齿轮副齿面接触分析结果，确定了端曲面齿轮齿面的修形位置.通过齿轮副对滚实验，验证了线接触端曲面齿轮齿面接触算法的正确性.

关键词: 端曲面齿轮, 齿面接触, 瞬轴面, 变传动比, 线接触

Abstract: To study contact characteristics of the curve-face gears， a transmission coordinate of curve-face gears was established. The instantaneous rotation axis and the axode of the curve-face gear were derived. The calculation method of meshing point of line contact curve-face gear was obtained based on the fundamental theorem of meshing tooth profile. The tooth contact prints and the tooth profile points were obtained in the view of geometry. The results of tooth contact analysis of the curve-face gear show that the positions of profile modification are determined. The calculation method of meshing point of line contact curve-face gear pair was verified via rolling experiments.

Key words: curve-face gear, tooth contact, axode, variable transmission ratio, line contact

中图分类号: