东北大学学报(自然科学版) ›› 2011, Vol. 32 ›› Issue (1): 129-132.DOI: -

• 论著 • 上一篇    下一篇

高密面层结构对针刺毡滤料性能影响的实验研究

柳静献;毛宁;常德强;孙熙;   

  1. 东北大学资源与土木工程学院;
  • 收稿日期:2013-06-19 修回日期:2013-06-19 发布日期:2013-04-04
  • 通讯作者: -
  • 作者简介:-
  • 基金资助:
    国家高技术研究发展计划项目(2007AA06Z346,2007AA061804)

Experimental study on the effect of high-density surface structure on filtration performance of needle-punched felt

Liu, Jing-Xian (1); Mao, Ning (1); Chang, De-Qiang (1); Sun, Xi (1)   

  1. (1) School of Resources and Civil Engineering, Northeastern University, Shenyang 110819, China
  • Received:2013-06-19 Revised:2013-06-19 Published:2013-04-04
  • Contact: Liu, J.-X.
  • About author:-
  • Supported by:
    -

摘要: 采用国标建议的实验装置,对普通针刺毡滤料和高密面层针刺毡滤料的性能进行系统实验与研究,得出了滤料阻力性能的数据.结果表明:高密面层滤料体现了表面过滤的特征,无论在洁净过滤阶段、老化阶段还是稳定过滤阶段都具有较低的阻力值、缓慢的阻力上升速度、较长的过滤周期、较高的粉尘剥离率.因此高密面层滤料结构优于普通滤料.

关键词: 滤料, 针刺毡, 高密面层, 袋式除尘, 阻力

Abstract: With an experimental setup used according to the National Standard, the filtration performance of both the common and high-density surface needle-punched felt as filters was systematically investigated, and the data of filtration resistance were obtained. The results showed that the high-density surface needle-punched felt as a filter shows the typical characteristics of surface filtration at different filtering stages, i.e., the fresh, aged, and stabilized filters are used sequentially. The high-density surface needle-punched felt is superior to the common one in filtration performance as follows: low filtration resistance and its slow increasing rate, long-time filtration cycle and high dust stripping rate.

中图分类号: