东北大学学报(自然科学版) ›› 2013, Vol. 34 ›› Issue (4): 532-535.DOI: -

• 材料与冶金 • 上一篇    下一篇

热连轧机AGC系统的优化

姬亚锋,张殿华,孙杰,李旭   

  1. (东北大学轧制技术及连轧自动化国家重点实验室,辽宁沈阳110819)
  • 收稿日期:2012-11-09 修回日期:2012-11-09 出版日期:2013-04-15 发布日期:2013-06-19
  • 通讯作者: 姬亚锋
  • 作者简介:姬亚锋(1986-),男,山东菏泽人,东北大学博士研究生;张殿华(1963-),男,内蒙古赤峰人,东北大学教授,博士生导师.
  • 基金资助:
    国家自然科学基金资助项目(51074051);中央高校基本科研业务费专项资金资助项目(N110307001).

Optimization of AGC System for Hot Strip Mills

JI Yafeng, ZHANG Dianhua, SUN Jie, LI Xu   

  1. State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110819, China.
  • Received:2012-11-09 Revised:2012-11-09 Online:2013-04-15 Published:2013-06-19
  • Contact: JI Yafeng
  • About author:-
  • Supported by:
    -

摘要: 针对传统AGC系统中弹跳方程受轧机刚度系数精度和弹跳曲线线性条件的影响而无法得到精确的机架轧出厚度的问题,提出以轧机弹跳特性曲线为基础的机架轧出厚度计算方法,并以此为基础得到新的前馈AGC、厚度计AGC及其与监控AGC的相关性模型.将优化后的AGC系统应用于某热连轧现场,实际应用表明,对于厚度规格35mm的带钢,允许厚度偏差±20μm时,厚度精度命中率可达962%以上,远优于现场控制要求.

关键词: 热连轧, 轧机弹跳特性曲线, 前馈AGC, 监控AGC, 厚度计AGC

Abstract: Aiming at the problem that the accurate rack rolled thickness was not available from the spring equation in the traditional automatic gauge control AGC system which was limited by the accuracy of mill stiffness coefficient and the linear conditions of the spring curve, a method based on the mill stretch characteristic curve was proposed to calculate the strip thickness, and then the new feed forward AGC, gaugemeter AGC and the correlation models between the gaugemeter AGC and monitor AGC were put forward. The optimized AGC system was applied successfully in a hot strip mill, and the practical application showed that the thickness of the strip steels with the specification of 35mm was controlled within the allowable thickness deviation of ±20μm, and the thickness precision validation rate reached over 962%, which satisfied the requirement of production site control.

Key words: hot strip mills, mill stretch characteristic curves, feedforward AGC, monitor AGC, thickness gauge AGC

中图分类号: