连铸结晶器内偏流及漩涡卷渣的实验研究

doi:10.12068/j.issn.1005-3026.2017.05.012

东北大学学报:自然科学版 ›› 2017, Vol. 38 ›› Issue (5): 666-670.DOI: 10.12068/j.issn.1005-3026.2017.05.012

连铸结晶器内偏流及漩涡卷渣的实验研究

刘中秋，李宝宽

(东北大学冶金学院，辽宁沈阳110819)

收稿日期:2015-12-09 修回日期:2015-12-09 出版日期:2017-05-15 发布日期:2017-05-11
通讯作者: 刘中秋
作者简介:刘中秋(1986-)，男，河北唐山人，东北大学讲师，博士；李宝宽(1963-)，男，辽宁辽阳人，东北大学教授，博士生导师.
基金资助:
国家自然科学基金资助项目(51604070);中央高校基本科研业务费专项资金资助项目(N161504009).

Experimental Studies on Asymmetrical Flow and Vortex Slag Entrapment in Continuous Casting Mold

LIU Zhong-qiu， LI Bao-kuan

School of Metallurgy， Northeastern University， Shenyang 110819， China.

Received:2015-12-09 Revised:2015-12-09 Online:2017-05-15 Published:2017-05-11
Contact: LIU Zhong-qiu
About author:-
Supported by:
-

摘要/Abstract

摘要：

连铸结晶器内的偏流和漩涡卷渣行为严重影响连铸坯的质量，因此建立了一套直弧型结晶器系统，研究了偏流和漩涡卷渣的运动规律.结果发现:偏流是由于流场自身的不稳定造成的，是时刻变化的;偏流发生在二冷区弯曲段附近.即使保证水口对中放置，结晶器上表面漩涡依然存在，多数情况下只有单个漩涡出现，其位置和大小是瞬变的.对称涡出现的机率较小，尺寸和强度较小，持续时间较短.同时考察了拉速、水口插入深度、滑动水口开度和中间包液位高度对偏流及其周期和漩涡卷渣的影响.

关键词: 连铸结晶器, 偏流, 漩涡卷渣, 水模型实验

Abstract:

The asymmetrical flow inside the mold and the slag entrapment induced by vortex at the top surface have great influences on the quality of continuous casting slab. One vertical-curved mold system was set to study the asymmetrical flow and slag entrapment behaviors. The results show that the asymmetrical flow in the mold is induced by the instability of the flow field itself and the flow pattern is not stationary but changed over frequently. The asymmetrical flow occurs near the bending section of the secondary cooling zone. Although the geometrical and operating conditions were made to be symmetric strictly， the vortex cannot be avoided. In the most cases， only one vortex took place and its size and position varies with time. The probability， size and strength of the symmetric vortex are very small and the durations is also short. Moreover， the effects of casting speed， gas injection rate， immersion depth of nozzle， slide gate opening， and liquid level height of tundish on the periodic asymmetrical flow and slag entrapment are analyzed.

Key words: continuous casting mold, asymmetrical flow, vortex slag entrapment, water model experiment

中图分类号:

TF777.1

刘中秋，李宝宽. 连铸结晶器内偏流及漩涡卷渣的实验研究[J]. 东北大学学报:自然科学版, 2017, 38(5): 666-670.

LIU Zhong-qiu， LI Bao-kuan. Experimental Studies on Asymmetrical Flow and Vortex Slag Entrapment in Continuous Casting Mold[J]. Journal of Northeastern University:Natural Science, 2017, 38(5): 666-670.

参考文献

[1]Robertson T，Moore P，Hawkine R J.Comutational flow model as aid to solution of fluid flow problems in the industry［J］.Ironmaking and Steelmaking，1986，13(4):195-203.
[2]Gupta D，Lahiri A K.A water model study of the flow asymmetry inside a continuous slab casting mold［J］.Metallurgical and Materials Transaction B，1996，27(10):757-764.
[3]Lawson N J，Davidson M R.Crossflow characteristics of an oscillating jet in a thin slab casting mould［J］.Journal of Fluids Engineering，1999，121(3):588-594.
[4]He Q L.Observations of vortex formation in the mould of a continuous slab caster［J］.ISIJ International，1993，33(2):343-345.
[5]Li B K，Tsukihashi F.An investigation on vortexing flow patterns in water model of continuous casting mold［J］. ISIJ International，2005，45(1):30-36.
[6]张胜军，朱苗勇，张永亮，等高拉速吹氩板坯连铸结晶器内的卷渣机理研究［J］.金属学报，2006，46(10):1087-1090.(Zhang Sheng-jun，Zhu Miao-yong，Zhang Yong-liang，et al Study on mechanism of entrapment in slab continuous casting mould with high casting speed and argon blowing［J］.Acta Metallurgica Sinica，2006，46(10):1087-1090.)
[7]Liu Z Q，Li B K，Jiang M F.Transient asymmetric flow and bubble transport inside a slab continuous-casting mold［J］.Metallurgical and Materials Transactions B，2014，45(4):675-697.
[8]Shen B Z，Shen H F，Liu B C.Instability of fluid flow and level fluctuation in continuous thin slab casting mould［J］. ISIJ International，2007，47(3):427-432. (上接第665页)
[2]Liu Z J，Zhang J L，Yang T J.Research and development of sintering flue gas desulphurization technology［J］.China Metallurgy， 2009，2:1-5，9.
[3]Liu W Q.Development of sintering flue gas desulfurization technology in iron and steel industry［J］.China Environmental Protection Industry，2009，5:24-27.
[4]Zhang H，Rao M，Fan Z，et al.Effects of circulated flue gas components on iron ore sintering［J］.ISIJ International，2012，52(12):2139-2144.
[5]Li G，Liu C，Rao M，et al.Behavior of SO₂ in the process of flue gas circulation sintering (FGCS) for iron ores［J］.ISIJ International，2014，54(1):37-42.
[6]董辉，李磊，蔡九菊，等.烧结余热回收竖罐内料层传热过程数值计算［J］.东北大学学报(自然科学版)，2012，33(9):1299-1302.(Dong Hui，Li Lei，Cai Jiu-ju，et al.Numerical simulation of heat exchange in vertical tank of waste heat recovery［J］.Journal of Northeastern University(Natural Science)，2012，33(9):1299-1302.)
[7]Wang S J，Zhu P，Zhang G，et al.Numerical simulation research of flow field in ammonia-based wet flue gas desulfurization tower［J］.Journal Energy Institute，2014，88(3):284-291.
[8]Wang X，Li Y，Zhu T，et al.Simulation of the heterogeneous semi-dry flue gas desulfurization in a pilot CFB riser using the two-fluid model［J］.Chemical Engineering Journal，2015，264:479-486.
[9]Ooi T C，Lu L.Formation and mitigation of PCDD/Fs in iron ore sintering.［J］.Febs Letters，2011，85(3):291-299.
[10]Wang G，Wen Z，Lou G，et al.Mathematical modeling of and parametric studies on flue gas recirculation iron ore sintering［J］.Applied Thermal Engineering，2016，102:648-660.
[11]Wang G，Wen Z，Lou G，et al.Mathematical modeling and combustion characteristic evaluation of a flue gas recirculation iron ore sintering process［J］.International Journal of Heat and Mass Transfer，2016，97:964-974.
[12]Yamaoka H，Kawaguchi T.Development of a 3-D sinter process mathematical simulation model［J］.ISIJ International，2005，45:522-531.
[13]Wang J，Zhong W.Simultaneous desulfurization and denitrification of sintering flue gas via composite absorbent［J］.Chinese Journal of Chemical Engineering，2016，24(8):1104-1111.
[14]潘建.铁矿烧结烟气减量排放基础理论与工艺研究［D］.长沙:中南大学，2007.(Pan Jian.Theoretical and process studies of the abatement of flue gas emissions during iron ore sintering［D］.Changsha:Central South University，2007.)
[15]Chen X L，Huang Y S，Gan M，et al.Effect of H₂O(g) content in circulating flue gas on iron ore sintering with flue gas recirculation［J］.Journal of Iron & Steel Research International，2015，22(12):1107-1112.

连铸结晶器内偏流及漩涡卷渣的实验研究

Experimental Studies on Asymmetrical Flow and Vortex Slag Entrapment in Continuous Casting Mold

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 8

编辑推荐

Metrics

本文评价

[1]	刘中秋，李林敏，李宝宽. 连铸结晶器内气泡群粒径分布的实验研究[J]. 东北大学学报:自然科学版, 2017, 38(1): 57-61.
[2]	刘中秋，齐凤升，李宝宽，姜茂发. 板坯连铸结晶器内渣/金界面非稳态波动行为[J]. 东北大学学报:自然科学版, 2014, 35(12): 1733-1737.
[3]	窦力威;于赋志;沈峰满;. 180t LF水模拟实验研究[J]. 东北大学学报(自然科学版), 2009, 30(8): 1131-1134.
[4]	郑淑国;朱苗勇;于海岐;曾小平;. 圆坯连铸结晶器电磁搅拌工艺参数优化试验研究[J]. 东北大学学报(自然科学版), 2008, 29(11): 1589-1592.
[5]	邓安元;赫冀成;贾光霖. 方坯凝固过程中夹杂物的运动轨迹[J]. 东北大学学报(自然科学版), 2000, 21(5): 532-535.
[6]	张雅静;符广;于光伟;贾光霖;高允彦. 电磁场控制连铸结晶器内弯月面区域金属流动状态的试验研究[J]. 东北大学学报(自然科学版), 2000, 21(1): 113--.
[7]	李永镇;周春林. 高炉软熔带特性及初渣流动规律的研究[J]. 东北大学学报:自然科学版, 1990, 11(4): 319-325.
[8]	王国雄;李永镇. 初渣流动方式对高炉内硅传递过程的影响[J]. 东北大学学报:自然科学版, 1989, 10(3): 238-244.