近距离煤层下行跨煤柱开采巷道的合理布局

doi:10.12068/j.issn.1005-3026.2023.01.014

摘要/Abstract

摘要： 为了探究遗留区段煤柱对下伏回采巷道布局的影响，以煤峪口矿为工程背景，通过最大主应力集中系数判别底板应力增高区，采用理论解析、编程计算、数值模拟的方法，研究了不同开采阶段底板应力增高区的演化特征.结果表明:区段煤柱宽度、埋深、煤柱边缘至峰值区的距离及其垂直应力峰值控制着应力增高区的发育，采空区应力恢复特征对应力增高区的影响可以忽略；对比各模拟方案中煤柱-巷道错距与应力增高区对下煤层的影响范围峰值，并结合采空区应力逐渐恢复及工作面矿压显现的区域化特征，认为煤柱-巷道错距10~15m为优选区间.选择12 m错距进行工业试验，取得了良好效果.

关键词: 近距离煤层；下行开采；遗留区段煤柱；采空区应力恢复；煤柱底板高应力

Abstract: Meiyukou coal mine was taken as engineering case to explore the influence of remnant coal pillar on the layout of underlying roadway. The maximum principal stress concentration coefficient was used to identify the concentrated stress zone in the floor. The evolution characteristics of concentrated stress zone in the floor at different mining stages were studied by means of theoretical analysis， programming calculation and numerical simulation. The results show that the width and the buried depth of pillar， the distance from edge of pillar to peak zone and the peak value of vertical stress control the development of concentrated stress zone in the floor. The influence of stress recovery characteristics of goaf on the concentrated stress zone can be ignored. Comparing the peak value of the influence range of concentrated stress zone on the lower coal seam and the staggered distance between coal pillar and roadway in each simulation scheme， and combining with the gradual recovery of stress in the goaf and the regionalization characteristics of ground pressure in longwall face， it is considered that the reasonable staggered distance range is 10~15m. Choosing staggered distance of 12m for industrial test has achieved good application effect.

Key words: close distance coal seams; downward mining; remnant coal pillar; stress recovery of goaf; high floor stress caused by coal pillar

中图分类号:

TD323

王泓博，张勇，庞义辉. 近距离煤层下行跨煤柱开采巷道的合理布局[J]. 东北大学学报（自然科学版）, 2023, 44(1): 100-109.

WANG Hong-bo， ZHANG Yong， PANG Yi-hui. Rational Layout of Roadway for Downward Cross-Pillar Mining in Close Distance Coal Seams[J]. Journal of Northeastern University(Natural Science), 2023, 44(1): 100-109.

参考文献

[1]钱鸣高，石平五，许家林.矿山压力与岩层控制［M］.徐州:中国矿业大学出版社，2010:218-221.(Qian Ming-gao，Shi Ping-wu，Xu Jia-lin.Ground pressure and strata control［M］.Xuzhou:China University of Mining & Technology Press，2010:218-221.)
[2]Zhang W，Zhang D S，Qi D H，et al.Floor failure depth of upper coal seam during close coal seams mining and its novel detection method［J］.Energy Exploration & Exploitation，2018，36(5):1265-1278.
[3]Sun J，Wang L G，Zhao G M.Stress distribution and failure characteristics for workface floor of a tilted coal seam［J］.KSCE Journal of Civil Engineering，2019，23(9):3793-3806.
[4]Liang Z Z，Song W C，Liu W T.Theoretical models for simulating the failure range and stability of inclined floor strata induced by mining and hydraulic pressure［J］. International Journal of Rock Mechanics & Mining Sciences，2020，132(1):1-21.
[5]Zhang M L，Zhang Y D.Stability evaluation method for gateways in closely spaced coal seams and surrounding rock control technology［J］.Arabian Journal for Science and Engineering，2018，43(10):5469-5485.
[6]Liu S L，Liu W T，Shen J J.Stress evolution law and failure characteristics of mining floor rock mass above confined water［J］.KSCE Journal of Civil Engineering，2017，21(7):2665-2672.
[7]Zhang N C，Zhang N，Esterle J，et al.Optimization of gateroad layout under a remnant chain pillar in longwall undermining based on pressure bulb theory［J］.International Journal of Mining，Reclamation and Environment，2016，30(2):128-144.
[8]高延法，肖洪天，张文泉.深井采场底板岩层移动观测与位移反分析［J］.岩土工程学报，1992，14(sup1):106-112.(Gao Yan-fa，Xiao Hong-tian，Zhang Wen-quan.Observation of strata movement and back analysis of displacements in the coal floor of a deep mine［J］.Chinese Journal of Geotechnical Engineering，1992，14(sup1):106-112.)
[9]Yavuz H.An estimation method for cover pressure re-establishment distance and pressure distribution in the goaf of longwall coal mines［J］.International Journal of Rock Mechanics & Mining Sciences，2004，41(2):193-205.
[10]Jiang L S，Zhang P P，Chen L J，et al.Numerical approach for gob-side entry layout and yield pillar design in fractured ground conditions［J］.Rock Mechanics and Rock Engineering，2017，50(11):3049-3071.
[11]Jiang Y D，Wang H W，Xue S，et al.Assessment and mitigation of coal bump risk during extraction of an island longwall panel［J］.International Journal of Coal Geology，2012，95(1):20-33.
[12]Cheng Y M，Wang J A，Xie G X，et al.Three-dimensional analysis of coal barrier pillars in tailgate area adjacent to the fully mechanized top caving mining face［J］. International Journal of Rock Mechanics & Mining Sciences，2010，47(8):1372-1383.
[13]Basarir H，Oge F，Aydin O. Prediction of the stresses around main and tail gates during top coal caving by 3D numerical analysis［J］.International Journal of Rock Mechanics & Mining Sciences，2015，76(8):88-97.
[14]Si G Y，Shi J Q，Durucan S，et al.Monitoring and modelling of gas dynamics in multi-level longwall top coal caving of ultra-thick coal seams， part Ⅱ: numerical modelling［J］.International Journal of Coal Geology，2015，144:58-70.
[15]陆士良，姜耀东，孙永联.巷道与上部煤层间垂距Z的选择［J］.中国矿业大学学报，1993，22(1):1-7.(Lu Shi-liang，Jiang Yao-dong，Sun Yong-lian.The selection of vertical distance Z between roadway and its upper coal seam［J］.Journal of China University of Mining & Technology，1993，22(1):1-7.)
[16]徐刚，于健浩，范志忠，等.国内典型顶板条件工作面矿压显现规律研究［J］.煤炭学报，2021，46(sup1):25-37.(Xu Gang，Yu Jian-hao，Fan Zhi-zhong，et al.Research on the characteristics of strata pressure behavior of working face under typical roof conditions in China［J］.Journal of China Coal Society，2021，46(sup1):25-37.)
[17]Zhang G J，Li Q S，Zhang Y，et al.Failure characteristics of roof in working face end based on stress evolution of goaf［J］.Geomechanics and Geophysics for Geo-energy and Geo-resources，2021，7(3):1-22.
[18]徐芝纶.弹性力学［M］.北京:高等教育出版社，2016:27-68.(Xu Zhi-lun.Elasticity［M］.Beijing:Higher Educational Press，2016:27-68.)
[19]Wilson A H.Stress and stability in coal ribsides and pillars［C］//Proceedings of the First International Conference on Ground Control in Mining.Morgantown:West Virginia University，1981:1-12.
[20]Yi K，Kang H P，Ju W J，et al.Synergistic effect of strain softening and dilatancy in deep tunnel analysis［J］.Tunnelling and Underground Space Technology，2020，97(1):1-12.
[21]许延春，李俊成，刘世奇，等.综放开采覆岩“两带”高度的计算公式及适用性分析［J］.煤矿开采，2011，16(2):4-7，11.(Xu Yan-chun，Li Jun-cheng，Liu Shi-qi，et al.Calculation formula of “two-zone” height of overlying strata and its adaptability analysis［J］.Coal Mining Technology，2011，16(2):4-7，11.)(上接第99页)(Han Jing-qing.Active disturbance rejection control technology:control technology for estimating and compensating uncertain factors［M］.Beijing:National Defense Industry Press，2008.)
[24]Cui X，Wang B，Lu H，et al.Design and passive training control of elbow rehabilitation robot［J］.Electronics，2021，10(10):1147-1163.
[25]Shi D，Zhang J，Sun Z，et al.Composite trajectory tracking control for robot manipulator with active disturbance rejection［J］.Control Engineering Practice，2021，106:104670.
[26]Hai X，Wang Z，Feng Q，et al.Mobile robot ADRC with an automatic parameter tuning mechanism via modified pigeon-inspired optimization［J］.IEEE/ASME Transactions on Mechatronics，2019，24(6):2616-2626.
[27]Chen F，Liao J，Xiong J，et al.High-precision trajectory tracking design and simulation for six degree of freedom robot based on improved active disturbance rejection control［J］.Proceedings of the Institution of Mechanical Engineers，Part C:Journal of Mechanical Engineering Science，2019，233(10):3659-3669.
[28]Huang Y，Xue W.Active disturbance rejection control:methodology and theoretical analysis［J］.ISA Transactions，2014，53(4):963-976.
[29]Meng X，Yu H，Zhang J，et al.Liquid level control of four-tank system based on active disturbance rejection technology［J］.Measurement，2021，175:109146.
[30]Lakomy K，Madonski R，Dai B，et al.Active disturbance rejection control design with suppression of sensor noise effects in application to DC-DC buck power converter［J］.IEEE Transactions on Industrial Electronics，2022，69(1):816-824.［31］张勇，陈增强，张兴会，等.基于自抗扰的四旋翼无人机动态面姿态控制［J］.吉林大学学报(工学版)，2019，49(2):562-569.(Zhang Yong，Chen Zeng-qiang，Zhang Xing-hui，et al.Dynamic surface attitude control of quad-rotor UAV based on ADRC［J］.Journal of Jilin University(Engineering and Technology Edition)，2019，49(2):562-569.)［32］李超，张智，夏桂华，等.基于强化学习的学习变阻抗控制［J］.哈尔滨工程大学学报，2019，40(2):304-311.(Li Chao，Zhang Zhi，Xia Gui-hua，et al.Learning variable impedance control based on reinforcement learning［J］.Journal of Harbin Engineering University，2019，40(2):304-311.)［33］Hamedani M H，Zekri M，Sheikholeslam F，et al.Recurrent fuzzy wavelet neural network variable impedance control of robotic manipulators with fuzzy gain dynamic surface in an unknown varied environment［J］.Fuzzy Sets and Systems，2021，416:1-26.