东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2010, Vol. 31 ›› Issue (8): 1105-1107.DOI: -

• 论著 • 上一篇    下一篇

铸轧高磷钢薄带表面磷富集层形成的探讨

邱以清;周国平;刘振宇;王国栋;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;
  • 收稿日期:2013-06-20 修回日期:2013-06-20 出版日期:2010-08-15 发布日期:2013-06-20
  • 通讯作者: -
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(50574018);;

On the formation of P-rich surface layer of twin-roll cast high-P strip

Qiu, Yi-Qing (1); Zhou, Guo-Ping (1); Liu, Zhen-Yu (1); Wang, Guo-Dong (1)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
  • Received:2013-06-20 Revised:2013-06-20 Online:2010-08-15 Published:2013-06-20
  • Contact: Qiu, Y.-Q.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

566

摘要： 为了更好地利用铸轧薄带表面溶质富集层,对高磷钢薄带表面磷富集层的成因进行了初步的分析和研究.实验结果表明,通过控制工艺参数,磷含量较高的铸轧薄带表面附近将有一个磷富集层出现,但在相同条件下磷含量较低的铸轧薄带中磷的分布基本均匀.通过理论分析得出,铸轧力驱使枝晶间富磷的液相回流到薄带表面附近,导致了磷富集层在铸轧薄带中的产生;表面磷富集层形成的前提条件是当源于铸轧辊表面的两凝固层相遇时Kiss点位于辊缝之上,且其下方附近区域横截面上的温度均处于液固线之间.

关键词: 磷富集层, 双辊铸轧薄带, 高磷钢, 铸轧力, Kiss点

Abstract: To take further the advantage of the solute-rich surface layer of twin-roll cast high-P steel strip, the causes for the formation of the P-rich surface layer were discussed. Experimental results indicated that there will be a P-rich layer nearby the surface of the higher-P strip after controlling the processing parameters, but the distribution of phosphorus is basically uniform in the lower-P strip under the same conditions. Theoretical analysis showed that the rolling force may drive the interdendritic P-rich liquid metal back onto the strip surface, thus resulting in the formation of the P-rich layer in the strip under the preconditions that the kiss point takes place above the bite and the cross-section temperature of the nearby region below the kiss point is between the liquidus and solidus temperature.

中图分类号: