止口及螺栓对法兰盘结构静力学特性的影响

doi:10.12068/j.issn.1005-3026.2022.10.010

东北大学学报（自然科学版） ›› 2022, Vol. 43 ›› Issue (10): 1438-1445.DOI: 10.12068/j.issn.1005-3026.2022.10.010

止口及螺栓对法兰盘结构静力学特性的影响

马辉，高昂，杨天瑞，官宏

(东北大学机械工程与自动化学院，辽宁沈阳110819)

修回日期:2021-10-20 接受日期:2021-10-20 发布日期:2022-11-07
通讯作者: 马辉
作者简介:马辉(1978-)，男，河北衡水人，东北大学教授，博士生导师.
基金资助:
国家自然科学基金资助项目(11972112).

Influence of Rabbets and Bolts on Static Characteristics of Flange Structures

MA Hui， GAO Ang， YANG Tian-rui， GUAN Hong

School of Mechanical Engineering & Automation， Northeastern University， Shenyang 110819， China.

Revised:2021-10-20 Accepted:2021-10-20 Published:2022-11-07
Contact: MA Hui
About author:-
Supported by:
-

摘要/Abstract

摘要： 以含止口配合的螺栓连接法兰盘结构为研究对象，利用ANSYS有限元软件进行数值仿真分析，基于接触算法与实体单元建模方法分析结构受横向载荷时的静力学特性，对比了含止口结构和无止口结构在接触状态和弯曲刚度上的差异.在此基础上，讨论了不同参数对接触特性和弯曲刚度的影响规律，为后续含止口螺栓连接法兰盘结构的设计提供一定参考.研究结果表明:对接触特性的影响，止口长度的增加有利于降低受压区域面积和接触压力的最大值；对弯曲刚度的影响，螺栓个数对弯曲刚度的影响占主导地位，其次是止口长度和摩擦系数，然后是螺栓预紧力，而止口过盈量对弯曲刚度的影响最小，同时良好的接触状态有利于提高结构弯曲刚度.

关键词: 止口；螺栓连接；接触特性；弯曲刚度；止口长度；过盈量

Abstract: The bolted flange structure with rabbet fit is taken as the research object， and the numerical simulation analysis is carried out by using ANSYS finite element software. Based on the contact algorithm and solid element modeling method， the static characteristics of the structure under lateral load are analyzed， and the differences of contact state and bending stiffness between the structure with rabbets and the structure without rabbets are compared. On this basis， the influence of different parameters on the contact characteristics and bending stiffness is discussed， which provides a reference for the subsequent design of flange structures with the rabbet-bolt connection. The results show that the increase of rabbet length is helpful to reduce the area of compression area and the maximum value of contact pressure， and the number of bolts is the most important factor affecting the bending stiffness， followed by the rabbet length and friction coefficient， and then the bolt preload， while the interference of rabbets has the least effect on the bending stiffness. At the same time， good contact state is conductive to improving the bending stiffness of the structure.

Key words: rabbet; bolted joint; contact characteristics; bending stiffness; rabbet length; interference

中图分类号:

TH131.9

马辉，高昂，杨天瑞，官宏. 止口及螺栓对法兰盘结构静力学特性的影响[J]. 东北大学学报（自然科学版）, 2022, 43(10): 1438-1445.

MA Hui， GAO Ang， YANG Tian-rui， GUAN Hong. Influence of Rabbets and Bolts on Static Characteristics of Flange Structures[J]. Journal of Northeastern University(Natural Science), 2022, 43(10): 1438-1445.

参考文献

[1]Kim J，Yoon J C，Kang B S.Finite element analysis and modeling of structure with bolted joints ［J］.Applied Mathematical Modelling，2007，31(5):895-911.
[2]Luan Y，Guan Z，Cheng G.The study on nonlinear dynamic behaviors of the structures with bolted-flange joint ［J］.IOP Conference Series:Materials Science and Engineering，2010，10(1):012172.
[3]Yao X Y，Wang J J，Zhai X.Research and application of improved thin-layer element method of aero-engine bolted joints ［J］.Proceedings of the Institution of Mechanical Engineers.Part G:Journal of Aerospace Engineering，2016，231(5):823-839.
[4]Ma Y H，Wang Y F，Wang C，et al.Nonlinear interval analysis of rotor response with joints under uncertainties ［J］.Chinese Journal of Aeronautics，2020，33(1):205-218.
[5]Luan Y，Guan Z Q，Cheng G D，et al.A simplified nonlinear dynamic model for the analysis of pipe structures with bolted flange joints ［J］.Journal of Sound and Vibration，2012，331(2):325-344.
[6]Wang C，Zhang D Y，Zhu X B，et al.Study on the stiffness loss and the dynamic influence on rotor system of the bolted flange joint ［C］// ASME Turbo Expo 2014:Turbine Technical Conference and Exposition.Montreal，2014:45769.
[7]郭文新，么宇辉，李韵，等.螺栓连接对高压转子结合面弯曲刚度的影响［J］.噪声与振动控制，2018，38(1):52-57.(Guo Wen-xin，Yao Yu-hui，Li Yun，et al.The influence of bolt joint characteristics on bending stiffness of rotor joint surface ［J］.Noise and Vibration Control，2018，38(1):52-57.)
[8]Liu S G，Ma Y H，Zhang D Y，et al.Studies on dynamic characteristics of the joint in the aero-engine rotor system ［J］.Mechanical Systems and Signal Processing，2012，29:120-136.
[9]Campos U A，Hall D E.Simplified Lamé′s equations to determine contact pressure and hoop stress in thin-walled press-fits ［J］.Thin Walled Structures，2019，138:199-207.
[10]Liu Y，Wang J，Chen L.Dynamic characteristics of the flange joint with a snap in aero-engine ［J］.International Journal of Acoustics and Vibrations，2018，23(2):168-174.
[11]王志，李吉凯，刘玉.带止口法兰连接结构刚度特性对结构振动影响［J］.航空动力学报，2019，34(6):1201-1208.(Wang Zhi，Li Ji-kai，Liu Yu.Stiffness characteristics of flange joint with a snap and its influence on structure vibration ［J］.Journal of Aerospace Power，2019，34(6):1201-1208.)
[12]李伦绪，陈果，于平超，等.止口螺栓连接结构非线性刚度机理分析及数值仿真［J］.航空动力学报，2021，36(2):358-368.(Li Lun-xu，Chen Guo，Yu Ping-chao，et al.Nonlinear stiffness mechanism analysis and numerical simulation of rabbet-bolted connection structure ［J］.Journal of Aerospace Power，2021，36(2):358-368.)
[13]岳伟，梅庆，张大义，等.高速可拆卸转子止口连接结构稳健性设计方法［J］.航空动力学报，2017，32(7):1754-1761.(Yue Wei，Mei Qing，Zhang Da-yi，et al.Robust design method of rabbet joint structure in high speed assemble rotor ［J］.Journal of Aerospace Power，2017，32(7):1754-1761.)
[14]张文胜，徐世俊，孟春晓，等.螺栓连接薄壁柱壳结构固有特性分析［J］.动力学与控制学报，2018，16(6):568-574.(Zhang Wen-sheng，Xu Shi-jun，Meng Chun-xiao，et al.Analysis of inherent characteristics of bolted thin-walled cylindrical shells ［J］.Journal of Dynamics and Control，2018，16(6):568-574.)

止口及螺栓对法兰盘结构静力学特性的影响

Influence of Rabbets and Bolts on Static Characteristics of Flange Structures

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价