东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2009, Vol. 30 ›› Issue (1): 83-85+89.DOI: -

• 论著 • 上一篇    下一篇

多道次可逆立-平轧制的数值模拟

王晓南;邸洪双;梁冰洁;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2009-01-15 发布日期:2013-06-22
  • 通讯作者: Wang, X.-N.
  • 作者简介:-
  • 基金资助:
    国家重点基础研究发展规划项目(2006CB605208)

Numerical simulation of reversible V-H multipass rolling process

Wang, Xiao-Nan (1); Di, Hong-Shuang (1); Liang, Bing-Jie (1)   

  1. (1) The State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2009-01-15 Published:2013-06-22
  • Contact: Wang, X.-N.
  • About author:-
  • Supported by:
    -

RichHTML

1

PDF (PC)

1027

摘要： 利用显示动力学方法和重启动方法,以现场实际轧制参数为基础,对5道次可逆立-平轧制过程进行了数值模拟.结果表明:厚件在轧制过程中容易产生双鼓变形,而薄件一般出现单鼓变形;立辊轧制可以有效地纠正双鼓变形,避免形成边部金属夹层;对角部节点进行跟踪发现角部的金属最终流动到板坯的上下表面;立轧具有一定的修复微小缺陷的作用,从而改善和提高了带钢的边部质量.该方法的应用为可逆轧制分析提供了新的分析方法,可以为立-平轧制的各道次提供准确的轧制参数.

关键词: 重启动方法, 立-平轧制, 数值模拟, 有限元, 鼓形

Abstract: Based on the actual data acquired in site, the reversible V-H 5-pass rolling process was numerically simulated with explicit dynamic method and restart method. The results showed that in the rolling process the thick slabs tend to double bulging deformation, while the thin ones exhibit single bulging deformation in general. The vertical or edge rolling can correct the double bulging deformation effectively so as to avoid metal sandwiches on the edge of workpiece. Tracking the corner nodes, it is found that the slab corner metal flows to both forward and back sides of workpiece. The vertical or edge rolling can repair tiny defects to a certain extent, thus improving the edge quality of rolled strip. The approach proposed is available to analyze the reverse rolling process and will provide exact rolling parameters for each and every pass of V-H rolling.

中图分类号: