东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2008, Vol. 29 ›› Issue (11): 1585-1588.DOI: -

• 论著 • 上一篇    下一篇

热带轧机工作辊初始辊型曲线的设计

赵旭亮;张殿华;徐建忠;刘相华;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2008-11-15 发布日期:2013-06-22
  • 通讯作者: Zhao, X.-L.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(50534020)

Initial profile design of work roll for hot strip mill

Zhao, Xu-Liang (1); Zhang, Dian-Hua (1); Xu, Jian-Zhong (1); Liu, Xiang-Hua (1)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2008-11-15 Published:2013-06-22
  • Contact: Zhao, X.-L.
  • About author:-
  • Supported by:
    -

RichHTML

1

PDF (PC)

493

摘要： 在采用影响函数法分析轧辊弹性变形的基础上,提出一种热带轧机工作辊初始辊型曲线的设计算法.指出合理分配精轧机组各机架带钢入、出口凸度范围对工作辊初始辊型曲线设计具有重要的作用,并提出一种各机架带钢入、出口凸度范围的确定策略.采用提出的算法对某厂1 250 mm热带轧机精轧机组优化了其工作辊初始辊型曲线,并进行了现场实际生产实验.实验结果表明:带钢的实测凸度满足该厂目标凸度的要求,证明了该算法的合理性.

关键词: 辊型曲线, 设计, 热带轧机, 工作辊, 凸度

Abstract: Introducing the influence function into the analysis of roll's elastic deformation, a design algorithm was proposed for the initial profile of work roll on hot strip mill. It was found that the reasonable strip crown distribution at entry and exit of each and every finishing stand plays an important role in the initial profile design of work roll. And a strategy was proposed to determine such a distribution. The work roll's initial profiles of 1250 mm HSMs in tandem were designed and optimized by the proposed algorithm. The results of in-situ tests showed that the measured strip crowns meet the requirements of target crown, thus verifying the reasonability of the algorithm.

中图分类号: