东北大学学报(自然科学版) ›› 2006, Vol. 27 ›› Issue (7): 768-770.DOI: -

• 论著 • 上一篇    下一篇

热轧带钢负荷分配目标厚度函数法

江潇;胡贤磊;刘相华;郭立合;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;东北大学轧制技术及连轧自动化国家重点实验室;东北大学轧制技术及连轧自动化国家重点实验室;本溪钢铁集团热连轧厂 辽宁沈阳110004;辽宁沈阳110004;辽宁沈阳110004;辽宁本溪117000
  • 收稿日期:2013-06-23 修回日期:2013-06-23 出版日期:2006-07-15 发布日期:2013-06-23
  • 通讯作者: Jiang, X.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(50104004)

Thickness target function method for load distribution during hot strip rolling

Jiang, Xiao (1); Hu, Xian-Lei (1); Liu, Xiang-Hua (1); Guo, Li-He (2)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China; (2) Hot Strip Mill, Benxi Iron and Steel Co., Benxi 117000, China
  • Received:2013-06-23 Revised:2013-06-23 Online:2006-07-15 Published:2013-06-23
  • Contact: Jiang, X.
  • About author:-
  • Supported by:
    -

摘要: 在分析了传统的解非线性方程组负荷分配方法缺陷的基础上提出目标厚度函数法.该方法首先建立总负荷与目标出口厚度的单调函数关系,而后给定目标厚度并对n个一维非线性方程求根得出各道次压下规程,避免了初始分配率限定问题,同时也对迭代过程中可能出现的轧制道次出口厚度大于入口厚度的异常情况做了处理.使用该方法并采用实际生产数据进行优化计算,结果表明该方法运算精确快捷,可以满足实时在线控制的要求.

关键词: 热轧, 带钢, 负荷分配, 非线性方程组, 目标厚度函数法

Abstract: Analyzing the defects of conventional solution to the set of nonlinear equations of rolling load distribution, a new method named thickness target function is proposed, i.e., a monotone function is derived between total load and target strip thickness at exit, and then the target thickness is given so as to solve nonlinear equations to obtain all the pass reductions. Thus, the method can avoid the strict constraint on initial load distribution rate and deal properly with the possible abnormality that in the iterative process a work piece at exit is thicker than at entry when passing a gauge reduction during rolling. An optimization calculation was done by the method in combination with in-situ data, and the results showed that the method is accurate and rapid in operation and meets the requirement of on-line real-time control.

中图分类号: