东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2004, Vol. 25 ›› Issue (9): 859-862.DOI: -

• 论著 • 上一篇    下一篇

半固态挤压扩展成形过程金属流动规律的有限元分析

王顺成;陈彦博;刘相华;温景林   

  1. 东北大学材料与冶金学院;东北大学材料与冶金学院;东北大学材料与冶金学院;东北大学材料与冶金学院 辽宁沈阳　110004
  • 收稿日期:2013-06-24 修回日期:2013-06-24 出版日期:2004-09-15 发布日期:2013-06-25
  • 通讯作者: Wang, S.-C.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金和上海宝钢集团公司联合资助项目(50274020);;

FEM analysis of metal flow behavior during continuous extruding/extending forming in semi-solid state

Wang, Shun-Cheng (1); Chen, Yan-Bo (1); Liu, Xiang-Hua (1); Wen, Jing-Lin (1)   

  1. (1) Sch. of Mat. and Metall., Northeastern Univ., Shenyang 110004, China
  • Received:2013-06-24 Revised:2013-06-24 Online:2004-09-15 Published:2013-06-25
  • Contact: Wang, S.-C.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

679

摘要： 利用有限元法对半固态连续挤压扩展成形过程中扩展腔内的金属流动规律进行模拟,得到了不同模具设计参数下的金属流动规律·结果表明,高固相率半固态金属浆料以层流方式填充模具,扩展腔内半固态金属浆料流动速度从扩展腔中心区域向两边侧壁逐渐减小·随着扩展角、模具台阶长度的增大,模具出口横断面上金属流动速度趋于更加均匀,随着模具定径带宽度增大,金属流动不均匀性增加,同时台阶太长,模具扩展腔两侧会出现金属流动的死区或涡流·在合理的模具设计条件下,可以实现半固态连续挤压扩展成形·

关键词: 半固态金属, 挤压扩展, 有限元方法, 模具设计, A2017合金

Abstract: How the metal flows in the extending cavity during continuous extruding/extending forming in semi-solid state was simulated by finite element method (FEM) to investigate the metal flow behavior in the moulds designed with different parameters. The calculated results indicate that the highly solidifiable semi-solid alloy fills in the extending mould in form of laminar flow and the flow velocity decreases gradually from the center to all sides in mould. The flow velocity at the outlet of mould becomes more even with increasing extending angle or step length. However, The flow velocity at the outlet of mould becomes more uneven with increasing outlet width. There is a dead zone or vortex flow on both sides of mould when the step is too long. It is proved that the continuous extruding/extending forming can be implemented only if the mould is designed rationally.

中图分类号: