东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2005, Vol. 26 ›› Issue (8): 770-773.DOI: -

• 论著 • 上一篇    下一篇

磨削加工表面粗糙度理论模型修正方法

修世超;李长河;蔡光起   

  1. 东北大学机械工程与自动化学院;内蒙古民族大学;东北大学机械工程与自动化学院 辽宁 沈阳 110004
  • 收稿日期:2013-06-24 修回日期:2013-06-24 出版日期:2005-08-15 发布日期:2013-06-24
  • 通讯作者: Xiu, S.-C.
  • 作者简介:-
  • 基金资助:
    教育部科学技术研究重点项目(104190)．

Modification for theoretical model of ground surface roughness

Xiu, Shi-Chao (1); Li, Chang-He (2); Cai, Guang-Qi (1)   

  1. (1) School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110004, China; (2) Inner Mongolia University for Nationalities, Tongliao 028042, China
  • Received:2013-06-24 Revised:2013-06-24 Online:2005-08-15 Published:2013-06-24
  • Contact: Xiu, S.-C.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

2624

摘要： 大多数计算磨削表面粗糙度的理论公式都是基于砂轮表面磨粒与工件表面的几何创成机理建立的.理论公式虽然计算精度较高,但由于对一些磨削条件的简化,特别是假定工件表面全部由切削过程完成而忽略了材料的塑性隆起变形对表面粗糙度的影响,使其计算结果往往小于实际表面粗糙度数值.分析了磨削加工表面塑性隆起对轮廓最大谷底高度的影响,提出了计算磨削表面粗糙度数值的塑性影响系数及其理论修正公式,并给出了理论计算与实验结果.

关键词: 磨削, 表面粗糙度, 塑性隆起, 轮廓谷底高度

Abstract: Most of the theoretic formulas to calculate the ground surface roughness are based on the geometrically generating interaction between grits and workpiece surface. Because of some simplifications especially the premise that the ground surface is formed completely just by cutting process, the effect of plastic upheaval deformation of workpiece surface on surface roughness is overlooked so as to cause the theoretic value of surface roughness to be often smaller than the real value. Analyzes the effect of plastic upheaval deformation on the maximum depth of the valley bottom of roughness profile and gives the plastic coefficients and modifies theoretical formulas of ground surface roughness. Compared with testing results, the calculated results by the formulas involving plastic coefficients are proved more accurate.

中图分类号: