东北大学学报（自然科学版）

东北大学学报:自然科学版 ›› 2015, Vol. 36 ›› Issue (1): 91-94.DOI: 10.12068/j.issn.1005-3026.2015.01.020

• 机械工程 • 上一篇    下一篇

磨削区气流运动特性仿真与实验研究

王宇钢， 裴少勇， 修世超   

  1. (东北大学 机械工程与自动化学院，辽宁 沈阳110819)
  • 收稿日期:2013-11-28 修回日期:2013-11-28 出版日期:2015-01-15 发布日期:2014-11-07
  • 通讯作者: 王宇钢
  • 作者简介:王宇钢(1977-)，男，辽宁锦州人，东北大学博士研究生; 修世超(1958-)，男，辽宁凌源人，东北大学教授，博士生导师.
  • 基金资助:
    国家自然科学基金资助项目(51375083).

Simulation and Experimental Research on Airflow Movement Characteristics of Grinding Zone

WANG Yu-gang， PEI Shao-yong， XIU Shi-chao   

  1. School of Mechanical Engineering & Automation， Northeastern University， Shenyang 110819， China.
  • Received:2013-11-28 Revised:2013-11-28 Online:2015-01-15 Published:2014-11-07
  • Contact: WANG Yu-gang
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

1074

摘要： 在对磨削区气流运动特性研究的基础上，应用FLUENT仿真软件建立磨削区有限元模型，仿真计算不同工作条件下磨削区气流的压力及速度分布特性.结合磨削加工实验，研究磨削区气流运动对工件表面完整性的影响并对仿真结果进行验证.研究结果表明，磨削区气流运动会阻碍磨削液有效进入磨削区.当磨削液喷入方位接近砂轮与气流运动的速度同向区时，可提高工件表面质量，磨削液的利用效果好，磨削过程绿色度得到提高.

关键词: 气流运动, 磨削液, 绿色度, 仿真, FLUENT

Abstract: Based on the research of airflow movement characteristics in the grinding zone， FLUENT was used to build the finite element model to simulate and calculate pressure distribution and velocity distribution on different working conditions. Combined with the grinding experiment， influence factors of airflow movement on the integrity of the work piece surface were studied and the simulation results were verified. The results indicated that airflow movement in the grinding zone impedes the grinding fluid into the grinding zone. When the injection position of grinding fluid was close to the area with the same direction of wheel rotation linear velocity and airflow velocity， the surface quality of the work piece improved， the utilization rate of grinding fluid and the green degree of grinding raised.

Key words: airflow movement, grinding fluid, green degree, simulation, FLUENT

中图分类号: