预制压型钢板混凝土组合板和钢梁连接及其有限元分析

doi:10.12068/j.issn.1005-3026.2022.04.016

东北大学学报（自然科学版） ›› 2022, Vol. 43 ›› Issue (4): 575-581.DOI: 10.12068/j.issn.1005-3026.2022.04.016

预制压型钢板混凝土组合板和钢梁连接及其有限元分析

王连广，蒙玉琪，王梓晴

(东北大学资源与土木工程学院，辽宁沈阳110819)

修回日期:2021-02-05 接受日期:2021-02-05 发布日期:2022-05-18
通讯作者: 王连广
作者简介:王连广(1964-)，男，辽宁鞍山人，东北大学教授，博士生导师.
基金资助:
国家自然科学基金青年基金资助项目(51808100)；辽宁省自然科学基金资助项目(2021-BS-278).

Connection of Precast Profiled Steel Sheet Concrete Composite Plate and Steel Beam and Its Finite Element Analysis

WANG Lian-guang， MENG Yu-qi， WANG Zi-qing

School of Resources & Civil Engineering， Northeastern University， Shenyang 110819， China.

Revised:2021-02-05 Accepted:2021-02-05 Published:2022-05-18
Contact: MENG Yu-qi
About author:-
Supported by:
-

摘要/Abstract

摘要： 为了满足预制组合板和钢梁连接节点的承载和变形要求，提出了一种新型的压型钢板混凝土组合板和钢梁整体预制的法兰板-螺栓连接节点.使用ABAQUS分别建立了现浇、预制节点模型，对比了两者在同等条件下的受力性能，并分析了栓钉数、组合板的厚度和长度、螺栓数和法兰板厚度对预制节点模型受力性能的影响.结果表明:预制节点的受力性能与现浇节点相似，设计预制节点时应采用96个栓钉、8个螺栓，以及200mm厚、5.1~6.6m长的组合板及10mm厚的法兰板.

关键词: 压型钢板混凝土组合板;板-梁连接节点;法兰板-螺栓连接;装配式结构;有限元分析;参数分析

Abstract: In order to meet the load-bearing and deformation requirements of precast composite plate and steel beam connection joints， a new type of flange plate-bolt connection joint with integral precast of profiled steel sheet concrete composite plate and steel beam was proposed. The cast-in-place and precast joint models were established by using ABAQUS respectively， the stress performance of which under the same conditions was compared， and the influence of the number of studs， the thickness and length of the composite plate， the number of bolts and the thickness of the flange plate on the stress performance of the precast joint model was analyzed. The results show that the stress performance of the precast joints is similar to that of the cast-in-place joints. The precast joints with 96 studs， 8 bolts， 200mm thick， 5.1~6.6m long composite plate and 10mm thick flange plate are suggested to be used when design.

Key words: profiled steel sheet concrete composite plate; plate-beam connection joint; flange plate-bolt connection; prefabricated structure; finite element analysis; parameter analysis

中图分类号:

TU398.9

王连广，蒙玉琪，王梓晴. 预制压型钢板混凝土组合板和钢梁连接及其有限元分析[J]. 东北大学学报（自然科学版）, 2022, 43(4): 575-581.

WANG Lian-guang， MENG Yu-qi， WANG Zi-qing. Connection of Precast Profiled Steel Sheet Concrete Composite Plate and Steel Beam and Its Finite Element Analysis[J]. Journal of Northeastern University(Natural Science), 2022, 43(4): 575-581.

参考文献

[1]杨晨康.闭口型压型钢板混凝土组合楼板抗火性能研究［D］.北京:清华大学，2018.(Yang Chen-kang.Research on fire resistance of composite slabs with re-entrant type decking［D］.Beijing:Tsinghua University，2018.)
[2]Kang C，Kang H T.Composite joints with fin plate connections under a middle column removal scenario［J］.Journal of Constructional Steel Research，2019，161:258-274.
[3]Siddh S P，Patil Y D，Patil H S.Experimental studies on behavior of composite slab with profiled steel sheeting［J］.Materials Today:Proceedings，2017，4(9):9792-9796.
[4]He X X，Li G C，Yang Z J.Experimental study of the bearing capacity of long-span profiled steel sheet-concrete composite slabs［J］.Advanced Steel Construction，2019，15(3):288-296.
[5]Li X，Zheng X Y，Ashraf M，et al.Experimental study on the longitudinal shear bond behavior of lightweight aggregate concrete-closed profiled steel sheeting composite slabs［J］.Construction and Building Materials，2017，156:599-610.
[6]Ali T，Yehia S，Didamouny M E.Analytical study on concrete slabs with decking profiled steel sheet［J］.International Journal of Advanced Research in Engineering and Technology ，2020，11(12):939-950.
[7]王承承.压型钢板-再生细骨料混凝土组合板纵剪承载力试验研究［D］.哈尔滨:哈尔滨工业大学，2020.(Wang Cheng-cheng.Experimental study on the longitudinal shear behavior of steel-recycled fine aggregate concrete composite slabs ［D］.Harbin:Harbin Institute of Technology，2020.)
[8]戎贤，陈磊，张健新.装配式钢管混凝土柱梁下栓上焊节点抗震性能试验［J］.东北大学学报(自然科学版)，2020，41(9):1348-1355.(Rong Xian，Chen Lei，Zhang Jian-Xin.Experimental study on seismic performance of bottom-flange-bolted and top-flange-welded prefabricated CFST column to steel beam joints ［J］.Journal of Northeastern University(Natural Science)，2020，41(9):1348-1355.)
[9]焦圣伦.新型异形钢管混凝土柱-钢梁装配式节点的抗震性能研究［D］.青岛:青岛理工大学，2019.(Jiao Sheng-lun.Study on seismic behavior of new special-shaped concrete filled steel tubular column-steel beam assembly joints ［D］.Qingdao:Qingdao University of Technology，2019.)
[10]Subhani M，Kabir M I，Alameri R.Strengthening of steel-concrete composite beams with composite slab ［J］.Steel and Composite Structures，2020，34(1):91-105.
[11]Katwal U，Zhong T，Hassan K.Finite element modeling of steel-concrete composite beams with profiled steel sheeting［J］.Journal of Constructional Steel Research，2018，146:1-15.
[12]Ellobody E，Young B.Performance of shear connection in composite beams with profiled steel sheeting［J］.Journal of Constructional Steel Research，2005，62:682-694.
[13]Hicks S J，Smith A L.Stud shear connectors in composite beams that support slabs with profiled steel sheeting［J］.Structural Engineering International，2014，24(2):246-253.
[14]Bonilla J，Bezerra L M，Mirambell E.Resistance of stud shear connectors in composite beams using profiled steel sheeting［J］.Engineering Structures，2019，187:478-489.
[15]Poliotti M，Bairan J M.A new concrete plastic-damage model with an evolutive dilatancy parameter［J］.Engineering Structures，2019，189:541-549.
[16]Hanif M U，Ibrahim Z，Ghaedi K，et al.Finite element simulation of damage in RC beams ［J］.Journal of Civil Engineering，Science and Technology，2018，9(1):50-57.

预制压型钢板混凝土组合板和钢梁连接及其有限元分析

Connection of Precast Profiled Steel Sheet Concrete Composite Plate and Steel Beam and Its Finite Element Analysis

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics

本文评价

[1]	戎贤，陈磊，张健新. 装配式钢管混凝土柱梁下栓上焊节点抗震性能试验[J]. 东北大学学报:自然科学版, 2020, 41(9): 1348-1355.
[2]	安国青，王蕊，赵晖，李铁英. 双钢板混凝土组合板在撞击荷载下的动力响应[J]. 东北大学学报（自然科学版）, 2022, 43(8): 1192-1200.