东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2004, Vol. 25 ›› Issue (2): 136-138.DOI: -

• 论著 • 上一篇    下一篇

NiFe_2O_4尖晶石粉体球磨制度

张淑婷;姚广春;刘宜汉;刘海石   

  1. 东北大学材料与冶金学院;东北大学材料与冶金学院;东北大学材料与冶金学院;龙口东海铝业有限责任公司 辽宁沈阳　110004
  • 收稿日期:2013-06-24 修回日期:2013-06-24 出版日期:2004-02-15 发布日期:2013-06-24
  • 通讯作者: Zhang, S.-T.
  • 作者简介:-
  • 基金资助:
    国家重点基础研究规划项目(G1999064903);;

Ball milling regime for NiFe2O4 spinel powder

Zhang, Shu-Ting (1); Yao, Guang-Chun (1); Liu, Yi-Han (1); Liu, Hai-Shi (2)   

  1. (1) Sch. of Mat. and Metall., Northeastern Univ., Shenyang 110004, China; (2) Longkou Donghai Aluminum Indust. Co., Longkou 265718, China
  • Received:2013-06-24 Revised:2013-06-24 Online:2004-02-15 Published:2013-06-24
  • Contact: Zhang, S.-T.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

564

摘要： 研究了球磨参数对NiFe2O4尖晶石粉料的颗粒粒径的影响·通过计算确定了试验所需钢球尺寸,在此基础上,进行正交试验选择合适的参数·试验结果表明,球磨时间是影响粒径的主要因素,而研磨体级配对粒径分布范围有较大影响·确定合适的球磨参数为:球磨时间36h;研磨体级配35∶40∶25;料球比1∶2;球磨介质的体积分数为75%·

关键词: NiFe2O4尖晶石, 颗粒尺寸, 球磨参数, 钢球尺寸, 正交试验

Abstract: Investigates the effect of ball milling parameters on the particle size of powdered NiFe2O4 spinel. Based on the ball size that was calculated to meet the requirement for lab test, a series of orthogonal tests were carried out to select parameters appropriate to the ball milling process. Test results showed that the duration of ball milling process is the predominant factor to the particle size, and the ball size grading also has an important effect on the distribution range of particle size. A set of optimum parameters for such a ball milling process is thus recommended as follows. Time required for ball milling: 36 h; ball size grading: 35:40:25; mass ratio of the stuff to mill to the ball: 1:2; and the volumetric percent of water contained in slurry: 75%.

中图分类号: