东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2011, Vol. 32 ›› Issue (4): 545-548.DOI: -

• 论著 • 上一篇    下一篇

帘线断裂时橡胶复合材料温度场数值模拟

刘均;刘小坡;方庆红;黄宝宗;   

  1. 东北大学理学院;沈阳化工大学材料科学与工程学院;
  • 收稿日期:2013-06-19 修回日期:2013-06-19 发布日期:2013-04-04
  • 通讯作者: -
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(10772122)

Numerical simulation of the temperature field in rubber composites during cord fracture

Liu, Jun (1); Liu, Xiao-Po (1); Fang, Qing-Hong (2); Huang, Bao-Zong (1)   

  1. (1) School of Sciences, Northeastern University, Shenyang 110819, China; (2) School of Material and Engineering, Shenyang University of Chemical Technology, Shenyang 110142, China
  • Received:2013-06-19 Revised:2013-06-19 Published:2013-04-04
  • Contact: Liu, J.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

551

摘要： 以单向帘线增强橡胶复合材料为研究对象,采用有限单元法建立二维计算模型.在周期性载荷作用下,对帘线断裂和帘线脱粘滑移引起的橡胶复合材料滞后生热的瞬态温度场进行了数值模拟,并讨论了帘线脱粘滑移摩擦对滞后生热的影响.结果表明,随着帘线断裂数目的增加,温度升高明显;脱粘摩擦生热对温升影响较小;帘线断裂引起的局部应力集中导致的大幅度温升是材料破坏的重要因素.分析结果对橡胶复合材料制品设计具有一定的参考价值.

关键词: 橡胶复合材料, 有限元, 帘线断裂, 脱粘, 滞后生热

Abstract: A two dimensional computation model was established by using FEM for unidirectional cord reinforced rubber composites. Given cord fracture and debonding slippage, the transient temperature field of rubber composites was simulated under cyclic loading to determine the effect of cord debonding slip friction on heat generation lag time. Temperature rose dramatically with cord fracture, while debonding slip friction caused a much lower temperature increase. The high temperature range increase caused by local stress concentration with cord fracture is an important factor affecting material failure. These results provide a valuable reference for the design of rubber composites products.

中图分类号: