非线性卸荷速率下的硬岩破坏特性与裂纹演化规律

doi:10.12068/j.issn.1005-3026.2022.07.014

摘要/Abstract

摘要： 为研究硬岩卸荷阶段速率非线性变化时的破坏特性，利用室内三轴压缩试验和颗粒流数值模拟开展余弦型、直线型和指数型三种卸荷速率变化方式的硬岩破坏研究.结果表明: 指数型卸荷的硬岩首先失稳破坏，余弦型卸荷的硬岩则不易发生破坏，前期较快的卸荷速率对整个卸荷过程的损伤积累影响更大；硬岩卸载过程中的承载强度受初始围压和卸荷方式的共同影响，且围压愈高则卸荷方式影响愈显著；根据Mogi-Coulomb准则，指数型卸荷通过内摩擦角影响硬岩强度，而直线型和余弦型卸荷的硬岩强度主要受黏聚力影响；指数型卸荷因前期快速卸荷易在端部产生部分破碎，直线型卸荷随围压升高由陡倾角剪切破裂带过渡多个“V”型剪切破坏，余弦型卸荷随围压增大呈塑性破坏特征趋势.

关键词: 硬岩；非线性卸荷速率；破坏特性；裂纹演化；颗粒流

Abstract: In order to study the failure characteristics of hard rock with nonlinear velocity variety in unloading phase， three unloading rate variety modes of cosine， linear and exponent were used to study the damage and failure of the hard rock by using the indoor triaxial compression tests and particle flow numerical simulation. The results show that the hard rock with exponential unloading rate first fails to stabilize， while the hard rock with cosine unloading rate is less likely to fail. The faster unloading rate in the early stage has a greater impact on the damage accumulation in the whole unloading process. The bearing strength of hard rock in unloading process is affected by both initial confining pressures and unloading modes， and the higher the confining pressure is， the more significant the influence of unloading mode is. According to the Mogi-Coulomb strength criterion， exponential unloading affects hard rock strength through internal friction angle， while the strength of hard rock under linear and cosine unloading mode is mainly affected by cohesion. Exponential unloading is easy to cause partial breakage at the end due to rapid unloading at the early stage. With the increase of confining pressure， linear unloading leads to multiple "V-shaped" shear failures from the steep dip shear fracture zone. Cosine unloading presents a plastic failure characteristic trend with the increase of confining pressure.

Key words: hard rock; nonlinear unloading rates; failure characteristics; crack evolutions; particle flow

中图分类号:

TU45

孙浩，朱东风，金爱兵，陈帅军. 非线性卸荷速率下的硬岩破坏特性与裂纹演化规律[J]. 东北大学学报（自然科学版）, 2022, 43(7): 1010-1018.

SUN Hao ， ZHU Dong-feng ， JIN Ai-bing ， CHEN Shuai-jun. Failure Characteristics and Crack Evolution Laws of Hard Rock Under Nonlinear Unloading Rates[J]. Journal of Northeastern University(Natural Science), 2022, 43(7): 1010-1018.

参考文献

[1]Zhu Z N，Tian H，Kempka T，et al.Mechanical behaviors of granite after thermal treatment under loading and unloading conditions［J］.Natural Resources Research，2021，30(3):2733-2752.
[2]Jiang Q，Zhang M Z，Yan F，et al.Effect of initial minimum principal stress and unloading rate on the spalling and rockburst of marble:a true triaxial experiment investigation［J］.Bulletin of Engineering Geology and the Environment，2021，80(2):1617-1634.
[3]Zhao H G，Song Z L，Zhang D M，et al.True triaxial experimental study on mechanical characteristics and energy evolution of sandstone under various loading and unloading rates［J］.Geomechanics and Geophysics for Geo-Energy and Geo-Resources，2021，7(1):1-17.
[4]Chen Y，Zuo J P，Li Z H，et al.Experimental investigation on the crack propagation behaviors of sandstone under different loading and unloading conditions［J］.International Journal of Rock Mechanics and Mining Sciences，2020，130:104310.
[5]Wang S S，Xu W Y，Yan L，et al.Experimental investigation and failure mechanism analysis for dacite under true triaxial unloading conditions［J］.Engineering Geology，2020，264:105407.
[6]许文松，赵光明，孟祥瑞，等. 大理岩真三轴单面卸荷条件下加卸载试验研究［J］.西南交通大学学报，2019，54(3):526-534.(Xu Wen-song，Zhao Guang-ming，Meng Xiang-rui，et al.Test study on true-triaxial loading and unloading for marble with unloaded single face［J］.Journal of Southwest Jiaotong University，2019，54(3):526-534.)
[7]Potyondy D O，Cundall P A.A bonded-particle model for rock［J］.International Journal of Rock Mechanics and Mining Sciences，2004，41(8):1329-1364.
[8]Cundall P A，Strack O D L.A discrete numerical model for granular assemblies［J］.Geotechnique，1979，29(1):47-65.
[9]Li X B，Chen Z H，Weng L，et al.Unloading responses of pre-flawed rock specimens under different unloading rates［J］.Transactions of Nonferrous Metals Society of China，2019，29(7):1516-1526.
[10]Shi C，Yang J X，Chu W J，et al.Macro-and micromechanical behaviors and energy variation of sandstone under different unloading stress paths with DEM［J］.International Journal of Geomechanics，2021，21(8):04021127.
[11]李江腾，刘双飞，赵远，等.不同应力路径下砂岩真三轴试验及数值模拟［J］.中南大学学报(自然科学版)，2021，52(3):693-700.(Li Jiang-teng，Liu Shuang-fei，Zhao Yuan，et al.True triaxial test and numerical simulation of sandstone in different stress paths［J］.Journal of Central South University(Science and Technology)，2021，52(3):693-700.)
[12]赵怡晴，刘佳伟，金爱兵，等.加卸荷条件下非贯通节理岩体破坏特性研究［J］.中南大学学报(自然科学版)，2020，51(7):1893-1901.(Zhao Yi-qing，Liu Jia-wei，Jin Ai-bing，et al.Study on failure characteristics of intermittent jointed rock mass under loading and unloading condition［J］.Journal of Central South University(Science and Technology)，2020，51(7):1893-1901.)
[13]Cao W Z，Li X B，Tao M，et al.Vibrations induced by high initial stress release during underground excavations［J］.Tunnelling and Underground Space Technology，2016，53:78-95.
[14]Li X B，Cao W Z，Zhou Z L，et al.Influence of stress path on excavation unloading response［J］.Tunnelling and Underground Space Technology，2014，42:237-246.
[15]朱杰兵.高应力下岩石卸荷及其流变特性研究［D］.武汉:中国科学院(武汉岩土力学研究所)，2009.(Zhu Jie-bing.Study on unloading mechanics and its rheological properties of rock under high stress［D］.Wuhan:Institute of Rock and Soil Mechanics，Chinese Academy of Sciences，2009.)
[16]Potyondy D O.A flat-jointed bonded-particle material for hard rock［EB/OL］.(2012-06-24)［2019-10-10］.http://onepetro.org/ARMAUSRMS/proceedings-abstract/ARMA12/All-ARMA12/ARMA-2012-501/120762.
[17]赵军，郭广涛，徐鼎平，等.三轴及循环加卸载应力路径下深埋硬岩变形破坏特征试验研究［J］.岩土力学，2020，41(5):1521-1530.(Zhao Jun，Guo Guang-tao，Xu Ding-ping，et al.Experimental study on deformation and failure characteristics of deeply-buried hard rock under triaxial and cyclic loading and unloading stress paths［J］.Rock and Soil Mechanics，2020，41(5):1521-1530.)
[18]Moji K.Fracture and flow of rocks under high triaxial compression［J］.Journal of Geophysical Research，1971，76(5):1255-1269.
[19]Al-Ajmi A M，Zimmerman R W.Relation between the Mogi and the Coulomb failure criteria［J］.International Journal of Rock Mechanics and Mining Sciences，2005，42(3):431-439.
[20]Feng F，Chen S，Wang Y，et al.Cracking mechanism and strength criteria evaluation of granite affected by intermediate principal stresses subjected to unloading stress state［J］.International Journal of Rock Mechanics and Mining Sciences，2021，143:104783.
[13]梅红，王勇.快速收敛的机器人滑模变结构控制［J］.信息与控制，2009，38(5):552-557.(Mei Hong，Wang Yong.Fast convergent sliding mode variable structure control of robot［J］.Information and Control，2009，38(5):552-557.)(上接第1009页)
[7]郑辉，唐国宝.Delta并联机械手几何误差建模及灵敏度分析［J］.哈尔滨工业大学学报，2009，41(7):252-255.(Zheng Hui，Tang Guo-bao.Geometric error modeling and sensitivity analysis of delta parallel manipulator ［J］.Journal of Harbin Institute of Technology，2009，41(7):252-255.)
[8]Lee S C，Zeng Q，Ehmann K F.Error modeling for sensitivity analysis and calibration of the tri-pyramid parallel robot ［J］.The International Journal of Advanced Manufacturing Technology，2017，93(5):1319-1332.
[9]Ni Y，Shao C，Zhang B，et al.Error modeling and tolerance design of a parallel manipulator with full-circle rotation ［J］.Advances in Mechanical Engineering，2016，8(5):1-16.
[10]房立金，孙龙飞.双电机驱动系统消隙特性研究［J］.中国机械工程，2012，23(24):2991-2996.(Fang Li-jin，Sun Long-fei.Research on clearance characteristics of dual motor drive system［J］.China Mechanical Engineering，2012，23(24):2991-2996.)
[11]孙龙飞，房立金.一种新型差动驱动A/B双摆头设计［J］.东北大学学报(自然科学版)，2016，37(9):1269-1273.(Sun Long-fei，Fang Li-jin.Design of a novel A/B birotary head based on differential drive［J］.Journal of Northeastern University(Natural Science)，2016，37(9):1269-1273.)
[12]程登元.一种双电机消隙伺服系统［J］.雷达科学与技术，2009(5):72-76.(Cheng Deng-yuan.Research on clearance characteristics of dual motor drive system［J］.Radar Science and Technology，2009(5):72-76.)
[13]Craig J J.Introduction to robotics:mechanics and control ［M］.London:Pearson Education Inc，1986.
[14]石则昌.机构精确度［M］.北京:高等教育出版社，1995.(Shi Ze-chang.Institutional precision ［M］.Beijing:Higher Education Press，1995.)