东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2008, Vol. 29 ›› Issue (10): 1435-1437+1442.DOI: -

• 论著 • 上一篇    下一篇

钛板的张力冷轧研究

吴迪;王贵桥;王敬东;王国栋;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2008-10-15 发布日期:2013-06-22
  • 通讯作者: Wu, D.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(50504007)

Investigation on cold rolling for titanium sheet under tensional effect

Wu, Di (1); Wang, Gui-Qiao (1); Wang, Jing-Dong (1); Wang, Guo-Dong (1)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2008-10-15 Published:2013-06-22
  • Contact: Wu, D.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

869

摘要： 针对钛板在无张力条件下冷轧效率低下的问题,首先结合钛材力学性能各向异性的特点,以Hill异性屈服准则为基础,推导出钛板在张力冷轧下的应力状态方程,从而在理论上阐明,钛板在张力条件下进行冷轧的可行性主要取决于其塑性变形条件及其所处的应力状态.然后在实验室的四辊可逆冷轧实验机上对钛板进行了张力冷轧实验研究.实验结果表明,钛板在适当的张力作用下冷轧,能够在保证良好板形的前提下实现单道次大压下量轧制,极大地提高了轧制效率.

关键词: 钛板, 冷轧, 张力, 各向异性, Hill异性屈服准则

Abstract: The inefficiency problem during cold rolling of titanium sheet without tension exerted on it was investigated. The state equation of stress of titanium sheet under tensional effect is deduced on the basis of Hill's anisotropic yield criterion in combination with the anisotropic characteristics of titanium's mechanical properties. It was found theoretically that the feasibility of cold rolling of titanium sheet under tensional effect mainly depends on titanium's plastic deformation conditions and the state of stress. An experimental investigation was therefore carried out on a 4-high reversible cold-rolling mill in lab for titanium sheet under tensional effect, and the result showed that heavy-reduction cold rolling process for titanium sheet just by single pass is available if the tension is chosen appropriately, from which the shape of sheet thus obtained is favorable with rolling efficiency improved remarkably.

中图分类号: