东北大学学报(自然科学版) ›› 2007, Vol. 28 ›› Issue (1): 72-75.DOI: -

• 论著 • 上一篇    下一篇

锰含量和工艺参数对低碳钢力学性能影响的正交试验

李龙;丁桦;杜林秀;宋红梅;   

  1. 东北大学材料与冶金学院;东北大学材料与冶金学院;东北大学轧制技术及连轧自动化国家重点实验室;宝钢集团公司技术中心 辽宁沈阳110004;辽宁沈阳110004;东北大学轧制技术及连轧自动化国家重点实验室;辽宁沈阳110004;辽宁沈阳110004;上海201900
  • 收稿日期:2013-06-27 修回日期:2013-06-27 出版日期:2007-01-15 发布日期:2013-06-24
  • 通讯作者: Li, L.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金;;

Orthogonal experiment of effects of Mn content and processing parameters on mechanical properties of low-carbon steel

Li, Long (1); Ding, Hua (1); Du, Lin-Xiu (2); Song, Hong-Mei (3)   

  1. (1) School of Materials and Metallurgy, Northeastern University, Shenyang 110004, China; (2) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China; (3) Technology Center, Baoshan Iron and Steel Group Co., Shanghai 201900, China
  • Received:2013-06-27 Revised:2013-06-27 Online:2007-01-15 Published:2013-06-24
  • Contact: Li, L.
  • About author:-
  • Supported by:
    -

摘要: 在正交设计的基础上,通过控轧控冷实验研究了锰含量、终轧温度和卷取温度对低碳钢力学性能的影响,通过统计技术对测得的力学性能数据进行了方差分析.结果表明,锰是影响实验钢强度和塑性指标的显著因素,而卷取温度对屈服强度的影响为显著.当锰质量分数为1.22%时,通过调整终轧温度和卷取温度可以使普通低碳钢的屈服强度超过400 MPa,综合性能良好.

关键词: 低碳钢, 正交试验, 锰, 工艺参数, 力学性能

Abstract: Based on orthogonal experiment, the effects of Mn content, finish rolling temperature (FRT) and coiling temperature (CT) on mechanical properties of low-carbon steel were investigated by TMCP (thermo-mechanical control processing), and the mechanical properties were examined by variance analysis. The results showed that Mn content affects obviously the strength and plasticity, while CT affects significantly the yield strength which can exceed 400 MPa with other mechanical properties also improved well by readjusting FRT and CT if the Mn content in tested steel is 1.22% as mass fraction.

中图分类号: