基于光流分析法检测钢水液位

doi:10.12068/j.issn.1005-3026.2018.02.002

东北大学学报:自然科学版 ›› 2018, Vol. 39 ›› Issue (2): 158-161.DOI: 10.12068/j.issn.1005-3026.2018.02.002

基于光流分析法检测钢水液位

苏志祁，何庆，谢植

(东北大学信息科学与工程学院，辽宁沈阳110819)

收稿日期:2016-09-07 修回日期:2016-09-07 出版日期:2018-02-15 发布日期:2018-02-09
通讯作者: 苏志祁
作者简介:苏志祁(1985-)，男，广西柳州人，东北大学博士研究生；谢植(1957-)，男，辽宁沈阳人，东北大学教授，博士生导师.
基金资助:
中央高校基本科研业务费专项资金资助项目(N140404022)；流程工业综合自动化国家重点实验室项目(2013ZCX01).

Molten Steel Level Measurement Based on Optical Flow Analysis

SU Zhi-qi， HE Qing， XIE Zhi

School of Information Science & Engineering， Northeastern University， Shenyang 110819， China.

Received:2016-09-07 Revised:2016-09-07 Online:2018-02-15 Published:2018-02-09
Contact: SU Zhi-qi
About author:-
Supported by:
-

摘要/Abstract

摘要： 在覆盖剂黏着于测温管表面的连铸中包中，基于视觉方法测量钢水液位系统无法通过温度场分析测量钢水液位.为此，本文使用光流分析算法跟踪测温管拔出钢水后表面黏着并向下流动的覆盖剂，检测出覆盖剂在测温管不同位置黏着特性的差异，并从微观角度分析覆盖剂在测温管表面的黏着特性与钢水液位的联系，最终计算出钢水液位.经验证，该方法所测得钢水液位误差在3mm以内.大量现场试验表明，该方法能较好地解决覆盖剂遮挡测温管表面温度信息的问题，使基于视觉方法的钢水液位测量系统在测温管黏着覆盖剂的异常情况下能准确可靠地测量出钢水液位.

关键词: 钢水液位, 液态覆盖剂, 测温管, 光流分析

Abstract: In some continuous caster， slag often adheres to the temperature-measuring tube. This phenomenon disturbs the vision-based molten steel level measurement system analyzing the temperature field of the temperature-measuring tube. To solve this problem， the liquid slag adhered on the tube lifted from the molten steel was tracked via optical flow analysis and the adherent characteristic in the different position of the tube was gathered， then the relation between the adherent characteristic and the molten steel level prior to lifting was analyzed， finally the molten steel level in the tundish was calculated. Validated by other methods， the error of this method is less than 3mm. Lots of on-site experiments indicate that this method may well solve the problem of missing temperature data， and accurately measure the molten steel level in the exceptional case of temperature-measuring tube adhering with liquid slag.

Key words: molten steel level, molten slag, temperature-measuring tube, optical flow analysis

中图分类号:

TP212.1

苏志祁，何庆，谢植. 基于光流分析法检测钢水液位[J]. 东北大学学报:自然科学版, 2018, 39(2): 158-161.

SU Zhi-qi， HE Qing， XIE Zhi. Molten Steel Level Measurement Based on Optical Flow Analysis[J]. Journal of Northeastern University Natural Science, 2018, 39(2): 158-161.

参考文献

[1]Solhed H，Jonsson L.An investigation of slag floatation and entrapment in a continuous-casting tundish using fluid-flow simulations，sampling and physical metallurgy［J］.Scandinavian Journal of Metallurgy，2003，32(1):15-32.
[2]Maneschg W， Laubenstein M，Budjá D，et al.Measurements of extremely low radioactivity levels in stainless steel for GERDA［J］.Nuclear Instruments and Methods in Physics Research Section A:Accelerators，Spectrometers，Detectors and Associated Equipment，2008，593(3):448-453.
[3]Kim G，Kim H，Oh K，et al.Level meter for the electromagnetic continuous casting of steel billet［J］.ISIJ International，2003，43(2):224-229.
[4]Katankin R A，Pokrovskiy A D.A study of the eddy-current method of testing the level of molten steel in the thin-slab crystallization process［J］.Russian Journal of Nondestructive Testing，2009，45(8):542-548.
[5]Katankin R A，Pokrovsky A D.An eddy-current probe for testing the level of molten steel［J］.Russian Journal of Nondestructive Testing，2010，46(3):216-221.
[6]Malmberg D，Bth L.Slag level detection in EAFs using microwave technology［J］.Scandinavian Journal of Metallurgy，1999，28(6):266-276.
[7]van den Berg F，Yang H.Real-time meniscus level and slag thickness measurement by RADAR［C］// Proceedings of the International Conference on Nondestructive Evaluation for Steel and Allied Industries.Jamshedpur，India，2011:12-20.
[8]Kim Y H，Lee D S，Hwang W H.Signal processing method of the molten steel height using CCD camera in the strip casting process［C］//International Conference on Modeling Identification and Control.Innsbruck，Austria，2002:102-108.
[9]Hu Z，Ci Y，Xie Z.Molten steel level measurement in tundish with heat transfer analysis［J］.ISIJ International，2011，51(10):1674-1681.
[10]Hu Z，Xie Z，Ci Y，et al.Molten steel level measuring method by thermal image analysis in tundish［M］//Recent Advances in Computer Science and Information Engineering.Berlin:Springer Berlin Heidelberg，2012:361-367.
[11]Schmitt N，Burr A，Berthaud Y，et al.Micromechanics applied to the thermal shock behavior of refractory ceramics［J］.Mechanics of Materials，2002，34(11):725-747.
[12]Irani M.Multi-frame optical flow estimation using subspace constraints［C］//The Proceedings of the Seventh IEEE International Conference on Computer Vision.Kerkyra，Greece，1999:626-633.

基于光流分析法检测钢水液位

Molten Steel Level Measurement Based on Optical Flow Analysis

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 5

编辑推荐

Metrics

本文评价

[1]	赵勇，何文正，汤永超. 基于伸缩杆结构的光纤光栅多级应变传感器[J]. 东北大学学报:自然科学版, 2018, 39(8): 1065-1069.
[2]	车勋建，谢植. 前置反射器比色高温计的研究[J]. 东北大学学报:自然科学版, 2018, 39(2): 162-165.
[3]	钱晓龙，张亚男. 基于光子晶体微腔和光纤环形衰荡的微力传感器[J]. 东北大学学报:自然科学版, 2018, 39(1): 11-14.
[4]	胡海峰，李雪刚，周雪，赵勇. 基于酒精选择性填充光子晶体光纤的Sagnac应变传感器[J]. 东北大学学报:自然科学版, 2016, 37(12): 1688-1691.
[5]	高朋，赵勇，李晋. 基于乙醇填充的光子晶体光纤温度传感器[J]. 东北大学学报:自然科学版, 2015, 36(10): 1369-1373.