东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2008, Vol. 29 ›› Issue (3): 339-342.DOI: -

• 论著 • 上一篇    下一篇

两相区热处理对不同初始组态钢板组织性能的影响

韩会全;刘彦春;张驰;王国栋;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;东北大学轧制技术及连轧自动化国家重点实验室;东北大学轧制技术及连轧自动化国家重点实验室;东北大学轧制技术及连轧自动化国家重点实验室 辽宁 沈阳 110004;辽宁 沈阳 110004;辽宁 沈阳 110004;辽宁 沈阳 110004
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2008-03-15 发布日期:2013-06-22
  • 通讯作者: Han, H.-Q.
  • 作者简介:-
  • 基金资助:
    国家高技术研究发展计划项目(2001AA332020)．

Effect of heat treatment in γ + α region on microstructures and properties of strips with different initial structures

Han, Hui-Quan (1); Liu, Yan-Chun (1); Zhang, Chi (1); Wang, Guo-Dong (1)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2008-03-15 Published:2013-06-22
  • Contact: Han, H.-Q.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

739

摘要： 采用0.08C-1.2Mn-0.15Si成分钢,研究了γ+α两相区退火+淬火工艺对不同初始组态钢板组织及力学性能的影响.在相同热处理制度下,初始晶粒越细,马氏体体积分数越多;同一初始组态钢板.保温时间在2～30 min内,随着保温时间延长,马氏体体积分数缓慢增长;经热处理后,得到铁素体+马氏体双相钢的力学性能:抗拉强度600 MPa级,加工硬化指数n值为0.17～0.22,屈强比0.50～O.60,延伸率大于20%.

关键词: γ+α两相区, 退火, 淬火, 组织性能, 双相钢

Abstract: The 0.08C-1.2Mn-0.15Si steel was investigated for the effect of annealing and quenching processes in γ + α region on the microstructures and properties of such strips of which the initial structures are different. It was found that under the same heat-treatment regime the finer the grains are, the more the volume fraction of martensite is. If the initial structures are the same, the volume fraction of martensite increases slowly with the lengthening holding time for 2-30 min. The tensile strength of specimens comes up to 600 MPa after annealing and quenching processes, and the initial work hardening index n varies in the range 0.17-0.22, with the ratio Rel/Rm 0.5-0.6 and percentage elongation higher than 20%.

中图分类号: