东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2013, Vol. 34 ›› Issue (8): 1171-1174.DOI: -

• 机械工程 • 上一篇    下一篇

航空发动机齿轮接触分析与修形研究

王丹，陆瑞成，闫玉涛，孙志礼   

  1. (东北大学机械工程与自动化学院，辽宁沈阳110819)
  • 收稿日期:2012-12-19 修回日期:2012-12-19 出版日期:2013-08-15 发布日期:2013-03-22
  • 通讯作者: 王丹
  • 作者简介:王丹(1960-)，女，辽宁沈阳人，东北大学副教授；孙志礼(1957-)，男，山东巨野人，东北大学教授，博士生导师.
  • 基金资助:
    航空科学基金资助项目(20090450001).

Modification Research and Contact Analysis of AeroEngine Gears

WANG Dan， LU Ruicheng， YAN Yutao， SUN Zhili   

  1. School of Mechanical Engineering & Automation， Northeastern University， Shenyang 110819， China.
  • Received:2012-12-19 Revised:2012-12-19 Online:2013-08-15 Published:2013-03-22
  • Contact: WANG Dan
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

1032

摘要： 基于齿轮啮合原理，在有限元分析软件ANSYS中采用APDL语言建立了齿轮传动三维参数化有限元模型.依据传热学和摩擦学理论，建立了单个轮齿的本体温度有限元分析模型，利用ANSYS软件求解出单个轮齿的本体温度场.将温度分布作为轮齿的温度载荷，计算轮齿的热变形，求出基于热变形的齿廓最大修形量.此外，依据经验公式，根据轮齿的受载情况计算齿廓的最大修形量.结合修形理论，得出了热弹耦合修正的渐开线齿廓修形曲线方程.通过ANSYS接触分析验证修形效果，得到修正后的修形曲线方程.

关键词: 渐开线齿廓, 齿廓修形, 热弹耦合分析, 接触分析, 有限元

Abstract: Based on principles of gear meshing， 3D parametric finite element model of the involute gear was built using the ANSYS parametric design language (APDL). The finite element model of single gear tooth body temperature was established， and then the bulk temperature field of gear tooth was obtained by the ANSYS， on the basis of heat transfer and friction theories. Taking the temperature distribution as the temperature load of the gear， thermal deformation was calculated by the maximum amount of modification for an involute tooth profile. Besides， the maximum amount of modification in terms of the force load on the gear was also calculated according to empirical formulas. Finally， the modification curve equation was revised through thermoelastic coupling analysis combined with the modification theory and then verified through the ANSYS contact analysis.

Key words: involute tooth profile, gear profile modification, thermoelastic coupled analysis, contact analysis, finite element

中图分类号: