东北大学学报（自然科学版）

东北大学学报:自然科学版 ›› 2015, Vol. 36 ›› Issue (10): 1441-1444.DOI: 10.3969/j.issn.1005-3026.2015.10.016

• 材料与冶金 • 上一篇    下一篇

基于田口法的钒钛磁铁矿热压块抗压强度的优化

赵伟， 储满生， 汤雅婷， 唐珏   

  1. (东北大学 材料与冶金学院， 辽宁 沈阳110819)
  • 收稿日期:2014-06-23 修回日期:2014-06-23 出版日期:2015-10-15 发布日期:2015-09-29
  • 通讯作者: 赵伟
  • 作者简介:赵伟(1991-)，男，安徽无为人，东北大学博士研究生； 储满生(1973-)，男，安徽岳西人，东北大学教授，博士生导师.
  • 基金资助:
    国家自然科学基金重大资助项目(51090384)；中央高校基本科研业务费专项资金资助项目(N130602003，N110202001).

Compressive Strength of Vanadium Titanium Magnetite Hot Briquette Based on Taguchi Method

ZHAO Wei， CHU Man-sheng ， TANG Ya-ting， TANG Jue   

  1. School of Materials & Metallurgy， Northeastern University， Shenyang 110819， China.
  • Received:2014-06-23 Revised:2014-06-23 Online:2015-10-15 Published:2015-09-29
  • Contact: CHU Man-sheng
  • About author:-
  • Supported by:
    -

RichHTML

1

PDF (PC)

691

摘要： 使用田口法探索了影响钒钛磁铁矿热压块抗压强度的重要因子，并通过信噪比分析计算各因子对抗压强度的贡献率，最终给出钒钛磁铁矿热压块的最佳制备条件.实验结果表明，在热压温度、配碳比、煤粉粒度三个影响因素中，煤粉粒度对抗压强度的影响程度最大，其贡献率达到了79.99%，温度和配碳比二者的贡献率分别为15%和3.63%.优化后钒钛磁铁矿热压块的制备参数为热压温度300℃、煤粉粒度<75μm、配碳比1.8.在优化后的参数下进行验证实验，得到的钒钛矿热压块的平均抗压强度达到1152.1N.

关键词: 田口法, 钒钛磁铁矿热压块, 抗压强度, 信噪比, 贡献率

Abstract: The Taguchi method was used to explore the important influence factors on the compressive strength of vanadium titanium magnetite hot briquettes， and then the contribution rates of these factors to the compressive strength were calculated through the signal-to-noise ratio analysis. Finally， the best preparation conditions of vanadium titanium magnetite hot briquettes were established. The results showed that among the three processing parameters including the hot-briquetting temperature， carbon ratio and coal particle size， the coal particle size was the most important factor to the compressive strength， and its contribution rate is up to 79.99%， the contribution rates of the hot-briquetting temperature and the carbon ratio were 15% and 3.63%， respectively. The optimized parameters of the preparation process of vanadium titanium magnetite hot briquette are as follow: hot-briquetting temperature 300℃， coal particle size less than 75μm， carbon ratio 1.8. Verification experiments were conducted with the optimized parameters， and the average compressive strength of the vanadium titanium magnetite hot briquette is up to 1152.1N.

Key words: Taguchi method, vanadium titanium magnetite hot briquette, compressive strength, signal-to-noise ratio, contribution rate

中图分类号: