Effect of Low Vacuum on Electroslag Remelting Process and Ingot Quality

doi:10.12068/j.issn.1005-3026.2023.01.008

Abstract

Abstract: Deoxidation and inclusions control are the key to improve the quality of ingots produced by electroslag remelting (ESR). The effect of low vacuum on the ESR process and ingot quality was experimentally studied in combination with thermodynamic calculations. H13 electrodes were remelted under argon protection at atmospheric and low vacuum (10kPa) conditions， respectively. The results show that， compared with atmospheric pressure， a higher gas content in the slag pool， more drastic fluctuations of the electrode melting rate， and a rougher surface of the ESR ingot were observed under low vacuum. The total w_O in the ESR ingots remelted under atmospheric and low vacuum conditions are 24×10^-6 and 18×10^-6， respectively. The carbon deoxidation reaction is greatly enhanced under low vacuum and gradually replaces aluminum deoxidation as the pressure decreases. Compared with Al-O equilibrium， the dissolved w_O in molten steel equilibrated with w_C of the electrode at 10kPa is much lower. Thus， lowering pressure can further reduce the w_O of the ingot. Carbon deoxidation， of which the product is CO gas， will not introduce new inclusions. The pressure has little effect on the type of inclusions in ESR ingots. The biggest inclusions in the ESR ingots remelted under atmospheric and low vacuum conditions decrease from 14.9μm to 10.5μm and 8.3μm， respectively. The ratio of the detected inclusions with equivalent diameters less than 3μm are 63.85% and 75.91%， respectively. ESR under low vacuum condition can further refine the inclusions and improve the cleanliness of ESR ingots.

Key words: electroslag remelting(ESR); low vacuum; deoxidation; inclusions; cleanliness; argon protection

CLC Number:

TF142

HUANG Xue-chi， LI Bao-kuan， LIU Cheng-jun， LIU Zhong-qiu. Effect of Low Vacuum on Electroslag Remelting Process and Ingot Quality[J]. Journal of Northeastern University(Natural Science), 2023, 44(1): 55-62.

References

[1] Zhang L F，Thomas B G.State of the art in the control of inclusions during steel ingot casting［J］.Metallurgical and Materials Transactions B，2006，37B: 733-761.
[2]Huang X C，Li B K，Liu Z Q，et al.Three-dimensional mathematical model of oxygen transport behavior in electroslag remelting process［J］.Metallurgical and Materials Transactions B，2018，49B: 709-722.
[3]Chen X C，Shi C B，Guo H J，et al.Investigation of oxide inclusions and primary carbonitrides in Inconel 718 superalloy refined through electroslag remelting process［J］.Metallurgical and Materials Transactions B，2012，43B: 1596-1607.
[4]王迪，杨树峰，曲敬龙，等.GH4169电渣重熔铸锭表层夹杂物分布规律［J］.钢铁，2021，56(2):155-161.(Wang Di，Yang Shu-feng，Qu Jing-long，et al.Distribution of inclusions on surface of GH4169 ESR ingot［J］.Iron and Steel，2021，56(2):155-161.)
[5]周德光，徐卫国，王平，等.轴承钢电渣重熔过程中氧的控制及作用研究［J］.钢铁，1998，33(3):13-17.(Zhou De-guang，Xu Wei-guo，Wang Ping，et al.Control and behavior of oxygen during electroslag remelting of bearing steel［J］.Iron and Steel，1998，33(3):13-17.)
[6]宋惠东，李晶，史成斌，等.8Cr13MoV钢电渣重熔过程中夹杂物行为［J］.钢铁，2016，51(8):41-48.(Song Hui-dong，Li Jing，Shi Cheng-bin，et al.Evolution of inclusions in 8Cr13MoV steel during ESR process［J］.Iron and Steel，2016，51(8):41-48.)
[7]李宝宽，王强.基于数值模拟的电渣重熔理论与技术［M］.北京: 科学出版社，2016: 1-2.(Li Bao-kuan，Wang Qiang.Theory and technology of electroslag remelting based on numerical simulation［M］.Beijing: Chinese Science Publishing，2016: 1-2.)
[8]Huang X C，Li B K，Liu Z Q，et al.Numerical study on the removal and distribution of non-metallic inclusions in electroslag remelting process［J］.International Journal of Heat and Mass Transfer，2019，135: 1300-1311.
[9]Du G，Li J，Wang Z B.Effect of operating conditions on inclusion of die steel during electroslag remelting［J］.ISIJ International，2018，58(1):78-87.
[10]Shi C B.Deoxidation of electroslag remelting (ESR)—a review［J］.ISIJ International，2020，60(6):1083-1096.
[11]Shi C B，Chen X C，Guo H J，et al.Assessment of oxygen control and its effect on inclusion characteristics during electroslag remelting of die steel［J］.Steel Research International，2012，83(5):472-486.
[12]侯栋，姜周华，董艳武，等.电渣重熔中脱氧剂种类影响炉渣脱氧的热力学分析［J］.东北大学学报(自然科学版)，2016，37(5):668-672.(Hou Dong，Jiang Zhou-hua，Dong Yan-wu，et al.Thermodynamics analysis of slag deoxidation with different deoxidizers during electroslag remelting process［J］.Journal of Northeastern University (Natural Science)，2016，37(5):668-672.)
[13]Choudhury A.Recent results of the electroslag remelting process under vacuum［C］//Proceeding of the Tenth International Conference on Vacuum Metallurgy.Beijing: Metallurgical Industry Press，1990: 247-251.
[14]Leach J.The application of vacuum to steel making［J］.Vacuum，1969，19(4):155-162.
[15]Steneholm K，Andersson M，Tilliander A，et al.Removal of hydrogen，nitrogen and sulphur from tool steel during vacuum degassing［J］.Ironmaking and Steelmaking，2013，40(3):199-205.
[16]Kuwabara T，Umezawa K，Mori K，et al.Investigation of decarburization behavior in RH-reactor and its operation improvement［J］.Transactions ISIJ，1988，28(4):305-314.
[17]You Z M，Cheng G G，Wang X C，et al.Mathematical model for decarburization of ultra-low carbon steel in single snorkel refining furnace［J］.Metallurgical and Materials Transactions B，2015，46B: 459-472.
[18]Sekiya A，Nakayama S，Taketsuru T.Deoxidation of stainless steel on vacuum electroslag remelting process［J］.Electric Furnace Steel (Denki-Seiko)，1995，66: 47-53.
[19]Radwitz S，Scholz H，Friedrich B.Investigation of slag compositions and pressure ranges suitable for electroslag remelting under vacuum conditions［C］//Proceedings of the 2013 International Symposium on Liquid Metal Processing & Casting.Berlin: Springer-Verlag，2013: 87-93.
[20]Liu Y，Zhang Z，Li G Q，et al.Investigation of fluoride vaporization from CaF₂-CaO-Al₂O₃ slag for vacuum electroslag remelting［J］.Vacuum，2018，158: 6-13.
[21]Chang L Z，Shi X F，Cong J Q.Study on mechanism of oxygen increase and countermeasure to control oxygen content during electroslag remelting process［J］.Ironmaking and Steelmaking，2014，41(3):182-186.
[22]Bjrklund J，Miki T，Andersson M，et al.Effect of temperature on oxygen activity during ladle treatment［J］.ISIJ International，2008，48(4):438-445.
[23]Liu Y，Wang X J，Li G Q，et al.Role of vacuum on cleanliness improvement of steel during electroslag remelting［J］.Vacuum，2018，154: 351-358.(上接第7页)