Journal of Northeastern University(Natural Science) ›› 2023, Vol. 44 ›› Issue (4): 517-523.DOI: 10.12068/j.issn.1005-3026.2023.04.008

• Materials & Metallurgy • Previous Articles     Next Articles

Microstructure Analysis of Mold Flux of Cao-SiO2-Al2O3-Na2O-MgO System for Ingot Casting

WANG Zhen1,2, JIANG Mao-fa1,2, LIU Cheng-jun1,2, MIN Yi1,2,3   

  1. 1. Key Laboratory for Ecological Metallurgy of Multimetallic Ministry
  • Published:2023-04-27
  • Contact: MIN Yi
  • About author:-
  • Supported by:
    -

Abstract: In order to clarify the influence mechanism of chemical composition change on physical properties of mold flux for ingot casting, the microstructure of CaO-SiO2-Al2O3-Na2O-MgO system slags were analyzed via Raman spectroscopy. The melt structure analysis results showed that there are five silicon oxygen tetrahedral structures Q0Si,Q1Si,Q2Si,Q3Si and Q4Si and three aluminum oxygen tetrahedral structures Q2Al,Q3Al and Q4Al in the slag. With the increase of basicity and the decrease of Al2O3 mass fraction, the tetrahedral structure with high degree of polymerization changes to low degree of polymerization, the number of non bridging oxygen in the slag increases and the degree of polymerization decreases. The physical property test results showed that the viscosity increases with the increase of Al2O3 mass fraction and decreases with the increase of basicity. The surface tension decreases with the increase of Al2O3 mass fraction and increases with the increase of basicity, which is consistent with the microstructure transformation behavior of slag. The effects of slag metal interfacial reaction on the microstructure, physical properties and behavior of slag entrapment are discussed.

Key words: mold flux; ingot casting; microstructure; Raman spectrum; physical property

CLC Number: