东北大学学报（自然科学版）

东北大学学报(自然科学版) ›› 2009, Vol. 30 ›› Issue (5): 661-664.DOI: -

• 论著 • 上一篇    下一篇

超纯铁素体不锈钢的组织、织构及深拉伸性能

刘海涛;刘振宇;王国栋;江来珠;   

  1. 东北大学轧制技术及连轧自动化国家重点实验室;宝山钢铁股份有限公司研究院;
  • 收稿日期:2013-06-22 修回日期:2013-06-22 出版日期:2009-05-15 发布日期:2013-06-22
  • 通讯作者: Liu, H.-T.
  • 作者简介:-
  • 基金资助:
    国家自然科学基金资助项目(50734002)

Microstructure, texture and deep drawability of ultra-purified ferritic stainless steel

Liu, Hai-Tao (1); Liu, Zhen-Yu (1); Wang, Guo-Dong (1); Jiang, Lai-Zhu (2)   

  1. (1) State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China; (2) BaoSteel Research Institute, Shanghai 201900, China
  • Received:2013-06-22 Revised:2013-06-22 Online:2009-05-15 Published:2013-06-22
  • Contact: Liu, H.-T.
  • About author:-
  • Supported by:
    -

RichHTML

0

PDF (PC)

1087

摘要： 重点研究了冷轧压下率对冷轧、再结晶织构的影响.结果表明:当终轧温度为750℃时,热轧带退火后以{111}再结晶织构为主.随着冷轧压下量的增加,γ织构减弱,α织构增强,{111}再结晶织构明显增强.当冷轧压下率为84%时,{111}再结晶组分的体积分数达到64.5%,退火板的平均塑性应变比(-R)高达1.69,平面各向异性(ΔR)仅为-0.17,深拉伸性能优良.

关键词: 铁素体不锈钢, 深拉伸性能, 显微组织, 冷轧, 织构

Abstract: The microstructure, texture and deep drawability of an ultra-low carbon/nitrogen ferritic stainless steel were investigated focusing on the influence of reduction on cold rolling and recrystallization texture. The results indicated that the hot-rolled strip after annealing is mainly characterized by {111} recrystallization texture when hot rolling is finished at 750°C. The orientation density of γ-fiber texture decreases but that of α-fiber texture increases with increasing cold rolling reduction. And, the orientation density of {111} recrystallization texture increases significantly as well. The volume fraction of {111} recrystallization component is up to 64.5% when the cold rolling reduction is 84%, and the cold-rolled sheet after annealing shows that its deep drawability is so favorable that the values of average strain ratio (R¯) and planar anisotropy (ΔR) are 1.69 and -0.17, respectively.

中图分类号: