东北大学学报(自然科学版) ›› 2013, Vol. 34 ›› Issue (6): 863-866.DOI: -

• 材料与冶金 • 上一篇    下一篇

硅藻土负载Ce-TiO2光催化材料的制备及性能研究

陈建设,熊领领,蔡安,刘奎仁   

  1. (东北大学材料与冶金学院,辽宁沈阳110819)
  • 收稿日期:2012-12-05 修回日期:2012-12-05 出版日期:2013-06-15 发布日期:2013-12-31
  • 通讯作者: 陈建设
  • 作者简介:陈建设(1969-),男,江苏新沂人,东北大学副教授;刘奎仁(1967-),男,辽宁锦州人,东北大学教授,博士生导师.
  • 基金资助:
    国家高技术研究发展计划项目(2012AA030314).

Preparation and Performance Research of CeTiO2/Diatomite Photocatalytic Materials

CHEN Jianshe, XIONG Lingling, CAI An, LIU Kuiren   

  1. School of Materials & Metallurgy, Northeastern University, Shenyang 110819, China.
  • Received:2012-12-05 Revised:2012-12-05 Online:2013-06-15 Published:2013-12-31
  • Contact: LIU Kuiren
  • About author:-
  • Supported by:
    -

摘要: 采用低温燃烧法制备硅藻土负载Ce-TiO2光催化材料,借助XRD,SEM对样品进行表征.以罗丹明B溶液为目标污染物,研究并确定了负载型光催化材料的最佳制备和光催化降解条件.结果表明,TiO2光催化材料的最佳煅烧温度为600℃,最佳Ce掺杂量为02%,制备的样品为锐钛矿和金红石组成的混合晶型,且锐钛矿占主要部分.最佳的光催化降解条件为:罗丹明B溶液初始质量浓度为10mg/L,催化剂用量为10g/L,溶液pH=9.制得的复合光催化材料失活再生后降解率可达93%,且可多次重复使用,光催化性能明显优于纯TiO2光催化材料.

关键词: 硅藻土, 低温燃烧法, TiO2, Ce掺杂, 光催化降解

Abstract: The CeTiO2/diatomite photocatalytic materials were prepared by lowtemperature combustion synthesis(LCS) method, which were characterized by XRD and SEM. The optimized photocatalytic preparation and degradation conditions of the supported photocatalytic materials were studied and determined, which selected Rhodamine B solution as the target pollutants. The results showed that the optimized calcination temperature was 600℃ and the optimized amount of doped Ce was 02%. The prepared samples were composed of anatase and rutile mixed polymorphs, and the anatase accounted for the major part. The optimized photocatalytic degradation conditions were Rhodamine B solution with initial concentration of 10mg/L, the amount of catalyst of 10g/L and the solution pH of 9. The degradation rate of the composite photocatalyst materials after deactivation and regeneration was 93%, and can be used repeatedly. Its photocatalytic performance was much better than that of the pure TiO2 photocatalytic material.

Key words: diatomite, LCS method, TiO2, Ce doping, photocatalytic degradation

中图分类号: