Journal of Northeastern University(Natural Science) ›› 2013, Vol. 34 ›› Issue (11): 1601-1605.DOI: 10.12068/j.issn.1005-3026.2013.11.020

• Materials & Metallurgy • Previous Articles     Next Articles

Comparison of the Effects of Different Additives on the Solid Phase Carbon Thermal Reduction of Ilmenite〓

LYU Xuewei, ZHANG Kai, HUANG Run, SONG Bing   

  1. College of Materials Science and Engineering, Chongqing University, Chongqing 400044, China.
  • Published:2013-07-09
  • Contact: LYU Xuewei
  • About author:-
  • Supported by:
    -

Abstract: The effects of adding FeSi, Na2B4O7, Na2CO3 on the solid phase reduction behaviors of ilmenite were studied with the thermogravimetric analysis (TG). From the analysis of the TG, DTG and DSC curves, the results showed that the mass loss ratio of the mixture of the ilmemite and coke during the reduction decreased by adding FeSi, while increased by adding Na2CO3 or Na2B4O7. All the three additives reduced the temperature at which the maximum reaction rate was obtained. The maximum mass loss rates of the reduction process both were increased with the addition of Na2CO3 or Na2B4O7 for 013%/min and 018%/min respectively; while the maximum mass loss rate decreased with the addition of FeSi. The mechanism of intensifying reduction of ilmenite were analyzed. The heat generated by the reaction of Si with Fe increases the temperature of reaction system. The mass transfer of the reactant during the reduction prcess is improved with the addition of Na2B4O7 due to its low melting temperature point, while the gasification reaction of C can be enhanced with the addition of Na2CO3.

Key words: ilmenite, additives, solid phase reduction, thermogravimetry, mass loss rates

CLC Number: